[SATXLS3]

So I had some concerns about dirt or water getting into my fuse box while the cover was at the paint shop. Did not want to ride around all week with it exposed. Here is an inexpensive solution. Went to wal-mart and bought a rubbermaid black plastic drawer tray $4.47 and a roll of black duct tape $3.37. Shortened the tray by cutting it and sliding it into itself to get the proper fit. width was good. Taped all the rough edges and taped it to the base. Due to the added height I had to temporarily remove the ram piston that lifts the hood until the original cover is done.