View Single Post
Old 12-12-2012, 11:57 AM   #4
HubStep's Avatar
Drives: 2010 Victory Red 2SS
Join Date: May 2012
Location: Atlanta
Posts: 433
PICTURE BLOCK 3 (Oldest -> Newest)
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >>>>>>>>>>>>
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >>>>>>>>>>>>

Basic outline of upgrades:

-RGB Wheel Light kit from Cosmic Creations/ weedahoe
-Slotted/drilled rotors
-MTI racing red braided stainless steel brake lines
-hawk ceramic pads
-Victory red powder coated calipers from mike the powder coater!
-DOT4 brake fluid

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >>>>>>>>>>>>

Getting started:

It's gonna be a good weekend

finally got her up on all fours!

bleed them dry!

painting all of weedahoe's kit black

One very unhappy cat, didn't get to sleep in the garage all weekend...

The coolest drill toy ever

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >>>>>>>>>>>>

Mounting the support brackets

Mounting the hoops

remove after test-fitting, time to lube up!

Racing Brake lines:

Time to get all the air bubbles out

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >>>>>>>>>>>>

Wheel Light picture time!

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >>>>>>>>>>>>

Wrap up:

Ok, so first let me say that mike @ is PHENOMENAL. His work is absolutely top-notch! Not only does he do a killer job with a superior method (that holds up to abuse), you basically get brand-new brakes that he rebuilds and guarantees for life. Seriously, if you wanna do this mod check this guy out. You won't be disappointed. He also will ship you a new set and once he gets the cores back refunds you $350. This was the best option for me as I needed to be able get my ride functional again as quick as possible.

Also, mike (weedahoe) at


hooked me up with the wheel light kit. It came with all the hardware I needed as well as a great controller and booster. Not only that, but his customer service was top-notch. Couldn't be happier! If you're wanting to go down the wheel light mod path and want RGB like I did then this guy is the way to go! I went with his V2 kit (you have to measure the diameter of your rotor/caliper). I went with 15 3/4th", though in hindsight I might have done 16" or 16 1/4th" and those SS brembos are a bitch to get around.

VIDEO of it all in action at top of page 1!

Last edited by HubStep; 12-12-2012 at 03:09 PM.
HubStep is offline   Reply With Quote