View Single Post
Old 11-28-2009, 04:11 PM   #5

FEN's Avatar
Drives: BLACK 2SS/RS
Join Date: Sep 2009
Location: Florida
Posts: 1,092 put car on lift and the Ebrake cables had quite a bit extra length.....started at front and began pulling cable thru mounts until both sides were over 1.5 inches away from wheels and allowing enough for wheel travel. To insure that the cable never creeps closer to wheels the service tech cut a piece of fuel line with same ID as the OD of Ebrake cable & slid it around the cable just behind the first mounting location (white bushing) and then installed a hose clamp around it.Looks fine and should work perfect to ensure cable does not move any closer to the wheels.
FEN is offline   Reply With Quote