Quote:
Originally Posted by PQ
Well, It seemed like a good idea.
There is NO 12 inch section of the Borla exhaust that isn't bent or have a turn in it so I can't put this 'Y' pipe in and fit the motors.
I might have to take it to a shop.
|
just bring it over to my place...lol
seriously tho... can you snap a pic of the area under your car? I'm trying to visualize it
Quote:
Originally Posted by PQ
There is one spot I could get them in at, right behind the would be cats just before the bend toward the center but it's tight enough that I can't know till I cut it. Even putting the assembly up to it it's very close. But I'd have to cut the ends off the cutouts and use the OEM coupling clamp. Which is OK but if it still didn't work then it would suck.
Best not to try it.
Grrrrrrrrrrrrrr.............
|
you may have to shorten the cutout itself. shouldnt be an issue so long as you can get the clamp to still work.