Thread: Drag radials?
View Single Post
Old 07-08-2012, 10:03 PM   #23
HufferSS
I Wanna Go Faster!!
 
HufferSS's Avatar
 
Drives: 2011 2SS Synergy Green M6
Join Date: Apr 2011
Location: SC
Posts: 3,323
Quote:
Originally Posted by AdamZ View Post
You guys are bickering over tires

Thanks for the info both of you. I will definitely check everything out.

Any chance you guys could link me to something since you probably have a better idea of what I need.

I will be putting them on the rear specifically for drags. When I am done I will be ptuuing the pirellis back on.

Forget these two bozos...I think they might be in love.

If you are going to use them for a strip only application and want to run your regular radials on the street then I would definitely go ET streets. They hook the best but are a terrible tire out on the street...any rain will put you in the ditch unless you slow down to a crawl and they won't wear very well.....but if you are willing to change them over to race then they hook the best.

Ninja edit: Jamie is right...go with 18s as the wheel choices are dirt cheap. Most people use Corvette wheels.

Ninja edit #2: If you are going to run your regular radials in the front then think twice about running the bias ply version of ET Streets.....mixing radials and bias can give you a squirrely ride on the big end. Many have done it, but be prepared if that's the route you go.

Good luck.
__________________
Built by Vengeance Racing
9.31@154.81 mph
Procharger F1-X
RPM Level 7 4L80e + Coan Converter
Hendrix 9" Rear Axle + 3.50 Gear
ARH 2" LTs+3.5" Exhaust
Fore Fuel System, Bogarts + Hoosier Slicks
Pfadt Drag Pack Suspension
My Build Thread | Best Pass To Date

Last edited by HufferSS; 07-08-2012 at 10:20 PM.
HufferSS is offline   Reply With Quote