Quote:
Originally Posted by Firefighter
|
That's pretty much it. Just little stuff to pay attention to. Don't torque on a lobe, make sure the bolt holes are clean and dry, put a little oil on everything before you close it up and run it.
Same process when you do the cam mostly. You will use an adjustable pushrod to set zero lash, then add somewhere around .075" for lifter preload to your measurement to figure out what length pushrods you need.
__________________
01000111011011110110111101100100001000000110110001 11010101100011011010110010000001110111011010010111 01000110100000100000011101000110100001101001011100 110010000001101111011011100110010100100001
x = ac97968bd3df8f968c8cd3df998a9c94d3df9c8a918bd3df9c 909c94df8c8a9c949a8dd3df92908b979a8ddf998a9c949a8d d3df8b968b8cd1
x = ~x