|
Hahaha, the fuel will be fixed soon enough!
Damn, I didn't think those hawks would be noisy at all. Did you properly bed them per hawks instructions when you first got them? If not, try now and see if the noise goes away. How's the brake dust in comparison to the stock pads?
This is hawks bed-in procedure for their brake pads:
After installing new brake pads, make 6 to 10 stops from approximately 30-35 mph applying moderate pressure.
Make an additional 2 to 3 hard stops from approximately 40 to 45 mph.
DO NOT DRAG BRAKES!
Allow 15 minutes for brake system to cool down.
After step 4 your new pads are ready for use.
|