Quote:
Originally Posted by CamaroSpike23
you do remember when I told you about QTPs ability to just bolt the turndown to the cutout right?
Exhaust pipe//Y-pipe//Cutout motor//Turndown
|
Yup. The cutouts I have coming today do the same thing.
Quote:
DO IT!
wait... you usually do the opposite of what I tell you...
|
Problem is my collectors from the headers go back about 8 inches further than the ones that were on Emmas car. So the tranny brace is right where her cutout motors were. In order to get them where hers were I have to move the O2 sensor and cut into the header literally a quarter inch from where the collectors straighten out. And put the O2 bung on the 'Y' pipe.
Or, move the cutout to the S pipes. Which will be fine, not like I;m going to miss the 2 hp from it being a foot behind but might not be as pretty.
OR, go with the noweeds system.
