Quote:
Originally Posted by newb
Nevermind. It's done.
|
So... what did you do?
I found this elsewhere:
Quote:
Camaro Wiring Instructions:
After you take off the door panel and install the gobo light you can then remove the door speaker. Behind the speaker there is a harness with a Red wire with a white stripe (slightly thicker than the others), this will be your power. The gobo will get power constantly and be triggered on and off by the ground (the correct way to setup LED lights).
On the driver side the ground for the door trigger is Grey w/ a Black stripe (connect black wire from gobo to this) on the passenger side it is a Tan w/ White stripe. Once you connect these the gobo will be on whenever you open the door and turn off as soon as you close the door.
Driver Side-
Red wire from Gobo connects to the Red wire w/ White stripe.
Black wire from Gobo connects to the Grey wire w/ Black stripe.
Passenger Side-
Red wire from Gobo connects to the Red wire w/ White stripe.
Black wire from Gobo connects to the Tan wire w/ White stripe.
|
And these threads also have good pics of the wiring:
http://www.camaro5.com/forums/showthread.php?t=291207
http://www.camaro5.com/forums/showth...68#post6272268