Quote:
Originally Posted by Darth_Emma
Gotcha. Thanks for the clarification. I've learned something new (once again) from the good folks at C5!
|
Thats what I'm here for.
Quote:
Originally Posted by PQ
Basically think about your old headers stopping short leaving room for cats. High flows or regualr, and the Borla headers not stopping short to leave room but stretching the primaries back further where there is no room for regular cats but maybe high flow cats.
Rigth there where your cutouts were, and are on your friends car, is where some high flow cats would go.
I have the X pipe version.
Attachment 345099
|
1st pic... areas where material can be removed (not including area on headers)
2nd pic... See what I did there?