Quote:
Originally Posted by MikeMoach
I want this scanner but don't wanna see the LEDs when it's off during the day, so gunna be that guy and ask can the face be ghost painted black?
|
I have had customers use "Night Shades" to tint the old scanner and you will be able to do the same with this scanner. Just note that your LEDs will not be as bright as without the paint/tint on the scanner.
Quote:
Originally Posted by LED Crazy
Ah! SOB. Jonathan is this still 3M taped back in order to secure it?
|
This new scanner will snap directly into the bumper so you do not have to use double stick tape!
Quote:
Originally Posted by LRod
No bending/snapping nor any cutting (I hope).
|
The scanner is pre-bent so you just remove the factory black "bezel", install the scanner, and connect the two wires (power and ground).
Quote:
Originally Posted by 2011 2SS/RS
great job correcting the #1 complaint about the old one....
this truly is plug and play.
|
Quote:
Originally Posted by rberns
Does this one require you to cut a hole in the bumper? If so then I probably won't be ordering this.
|
You do not have to cut anything in your bumper anymore; this scanner will replace the black "bezel" that comes from the factory on your Camaro!