View Single Post
Old 05-13-2014, 12:45 PM   #10
BMR Sales

BMR Sales's Avatar
Drives: Race Car
Join Date: Sep 2009
Location: Seffner, FL
Posts: 4,886
Originally Posted by NotYetLegend View Post
Yikes, that is extremely confusing. I will order up the BMR kit with the intent of drilling out the bar ends to 12mm (should be easy enough). When I do lower it I'll look for adjustable links that are 12mm so they bolt right on. Will go ahead and order the BMR reinforcement plates for the rear mounts as well for the piece of mind. Thanks again Keith for taking the time to help me out.
Sounds good, but you don't need those reinforcement plates (ELK009), those are for FE3 Rear Suspensions only!!!
T.C. Davis
Sales/Suspension Pro
BMR Sales is offline   Reply With Quote