View Single Post
Old 05-13-2014, 06:08 PM   #13
JDP Sales

JDP Sales's Avatar
Drives: Chevys at the limit
Join Date: Nov 2010
Location: SLC, UT
Posts: 9,583
Originally Posted by BMR Sales View Post
The only issue I would see with this is the front bar in the SB039 kit is bent differently to accommodate the electric power steering, which the OP doesn't have. It may still fit in there fine, but I would to eliminate the extra bends in the bar if they aren't needed. Just my .02 cents.
It will fit, we have done it in the past. I would still rather have a couple extra bends in the bar than have to drill out the holes and mess up the powdercoat and have potential rust issues.

Best regards,


Click HERE to send me a PM | | | 801-545-4215
JDP Sales is offline   Reply With Quote