View Single Post
Old 10-17-2008, 09:58 AM   #20
My boredom isn't safe
Chewy's Avatar
Drives: 2010 SS Camaro
Join Date: Sep 2008
Location: Jacksonville, FL
Posts: 1,223
Send a message via AIM to Chewy Send a message via MSN to Chewy
Originally Posted by Dan View Post
1. There is a structural support right behind the slot so your idea would not fit.
2. There is no such thing as ram air.
Ram-air intake

From Wikipedia, the free encyclopedia

Jump to: navigation, search

A ram-air intake is any intake design which uses the dynamic air pressure created by vehicle motion to increase the static air pressure inside of the intake manifold on an engine, thus allowing a greater massflow through the engine and hence increasing engine power.
The ram air intake works by reducing the intake air velocity by increasing the cross sectional area of the intake ducting. When gas velocity goes down the dynamic pressure is reduced while the static pressure is increased. The increased static pressure in the plenum chamber has a positive effect on engine power, both because of the pressure itself and the increased air density this higher pressure gives.
Ram-air systems are used on high performance vehicles, most often on motorcycles and race cars. Ram-air has been a feature on some cars since the late sixties, but fell out of favor in the seventies, and has only recently made a comeback. Modern parachutes use a ram-air system to pressurise a series of cells to provide the aerofoil shape.
At low speeds (subsonic speeds) increases in static pressure are however limited to a few percent. Given that the air velocity is reduced to zero without losses the pressure increase can be calculated according to:
dP / P = (v2) / (2RT)
Chewy is offline   Reply With Quote