Hope this thread isn't too dead by now...
I'm at 486rwhp and 467rwtq on a Mustang Dyno, my current set up is:
L99
Edelbrock SC w/ 3.5" pulley (upgraded from the 3.875") (w/ the 52 lb injectors)
Borla LT Headers
Cat Delete, resonator delete, straight pipe to flowmaster mufflers
AEM Cold Air Intake
Tune
I want to break the 500rwhp mark, hopefully it can take some easy mods to get there?
will the 3.25" pulley be too much PSI for my set up? unless anyone else can tell me some easy & not so expensive mods to go with to get me to the 500rwhp range?
My overall goal was originally 550rwhp, but i'm trying to avoid having to put a cam in and i don't want forged internals... but if that's the way, then that's the way, so i've dropped it to 500rwhp.
-May
|