[MS3DALE]

Originally Posted by MS3DALE

Theres a TSB on the issue Brendan.

Originally Posted by Bumblebee2012

Does anyone know of the TSB number for the broken lens?

Service Information


2011 Chevrolet Camaro | Camaro VIN F Service Manual | View All Bulletins | Document ID: 2777232
#PI0685: GM Accessory and Camaro Transformer High Wing Spoiler Center High Mount Stop Lamp (CHMSL) Cracking Around Fasteners - (Feb 28, 2012)

Subject:GM Accessory and Camaro Transformer High Wing Spoiler Center High Mount Stop Lamp (CHMSL) Cracking Around Fasteners

Models:2010-2012 Chevrolet Camaro (U.S. and Canada Only)

Condition/Concern




Some customers may comment on the CHMSL developing cracks in the area around the fasteners.
Recommendation/Instructions


DO NOT REPLACE THE SPOILER for this condition.
Replace the CHMSL high mount stop lamp using the following procedure:

1. Use a pick to remove the caps that cover the CHMSL screws.

2. Remove the screws from the CHMSL. Screws were installed with Loc-Tite. Some amount of force may be necessary to loosen the screws.

3. Unplug the CHMSL from the wiring harness. Be careful the harness does not slip back into the spoiler.
4. Connect the new CHMSL wiring harness.
5. Install the washers on the new spoiler. We recommend using Butyl to hold the washers in place when installing the CHMSL to spoiler. Tighten to 1.85N·m+/- .15.

6. Install caps over the fasteners to complete the repair.

Parts Information


To obtain the new Spoiler CHMSL (WPC#630), fax the form included in this PI to the GM Warranty Parts Center (WPC).
Warranty Information


For vehicles repaired under warranty, use:

Labor Operation



Description



Labor Time



B6812*


Replace Spoiler CHMSL


0.3 hr


*This is a unique labor operation for bulletin use only. It will not be published in the Labor Time Guide.

IMPORTANT NOTE WHEN PRINTING THIS FORM: If the form prints out on two pages, make certain you fax BOTH pages so that the WPC receives all the needed information. Missing information will delay or prevent the part from being shipped.

Parts Request Form – Warranty Parts Center



Use this form ONLY for U.S., Canadian and Mexico Dealers. Export markets located outside of North America must contact their regional Technical Assistance Center for assistance.

To: Warranty Parts Center

 

e-mail: warrantypartscenterUSA@gm.com

 

or WPC Fax: 248-371-XXXX

 

Attn: Jeanette Dunn

 

Part Being Requested: #630 CHMSL Service Kit

 

Dealer BAC (U.S.) /Dealer Code (Canada)/Dealer Number (Mexico):

 

Dealer Name:

 

Dealer Address:

 

 

Dealer Contact Person:

 

Dealer Phone Number:

 

Repair Order Number:

 

Vehicle VIN:

 

Important: If you do not receive the part within 2 business days after e-mailing or faxing your part request to the Warranty Parts Center, please call Customer Assistance at 248-371-XXXX.IMPORTANT NOTE WHEN PRINTING THIS FORM: If the form prints out on two pages, make certain you fax BOTH pages so that the WPC receives all the needed information. Missing information will delay or prevent the part from being shipped.



GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.

WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION

© 2012 General Motors. All rights reserved.