|
Set up for stock 2.5" SS exhaust. You should use them if you are running headers and want to open up the exhaust note. Mounted in the rear decreases cabin noise considerably, removes heat from under the seat and system wiring is not exposed to heat which negatively affects a remote control system and the actuators. When they were under the seat I had to wrap actuating system with heat protectors which are no longer required. Used with locking bolts these do not leak by at all behind the axle and I moved them because of all of the above reasons. I left a portion of stock exhaust so you would know where to cut out your exhaust and weld in this system. Any exhaust shop should be able to completely mount this system in under 2 hours including setting up wiring controls. already being pre-made eliminates the trial and error of installation.
|