A few questions about qtp electronic cutout switch install.
I received my low profile cutouts that I ordered from Dynosteve @ RDP. Ive looked at the DIY thread and understand the install of the cutouts and the routing of the wiring. But when it comes to installing the switch there's not really any information. I think the DIY is for the key fob controller because it instructs to run the wires to the center console.
If possible I would like to mount my switch on the dash in the spot where the hud controls would be if I had the hud. (See picture) does anyone know if the wires that come with the qtp kit are long enough to reach this area? Is there enough room behind the dash for the large switch qtp sends with their kit? Also would I be able to use a fuse tap as a power source for the kit so I don't have to cut into anything? I've already tapped into my cigarette lighter to power my lc2.
__________________
Stainless Power Longtube headers, off road mids, stock H pipe, flowmaster mufflers, Vararam tune model intake, NightFury cam, and 91 octane email tune from Dynosteve @ rdpmotorsport.com. 473 rwhp and 430 ft. Lbs. @3,235 ft elevation.
|