Quote:
Originally Posted by PQ
Yup. The cutouts I have coming today do the same thing.
|
good. use them
Quote:
Originally Posted by PQ
Problem is my collectors from the headers go back about 8 inches further than the ones that were on Emmas car. So the tranny brace is right where her cutout motors were. In order to get them where hers were I have to move the O2 sensor and cut into the header literally a quarter inch from where the collectors straighten out. And put the O2 bung on the 'Y' pipe.
|
BS. see pictures and comments below for some options
Quote:
Originally Posted by PQ
Or, move the cutout to the S pipes. Which will be fine, not like I;m going to miss the 2 hp from it being a foot behind but might not be as pretty.
|
again... how bout moving the S pipes back slightly to allow you more room and that way you wont have to move the o2 sensor.
You should have a straight section of pipe (may be under the driveshaft, but you could notch out an extra 4" out of there and cut behind the o2 sensor, then slide the whole assembly back in order to fit the ypipe and cutout and still clear the trans brace and floor.
does anyone make a smaller trans brace btw?