|
I did my header install today and used this post as a reference. Thank you for the help. A couple of things I would add based on my install. I installed Stainless Works headers and had to modify the mounting arm of the dipstick tube. The header flange was thicker than the stock manifold and that would not allow the holes to align. Just a little material removal with a grinder and it fit. Secondly, I had to remove the ground cable from the passenger side. Again, the header flanges are thicker and I could not get the flange to set agains the head with out removing the ground. Once the header was installed, the ground strap installed over the flange just fine.
|