You are browsing camaro5 
 |
|
06-04-2011, 07:45 PM
|
#1 |
|
ready...
|
Sheared the OEM air box stud...
I have an Cold air inductions CAI installed, and was going to use the free oem air box stud to mount my catch can. In the process of installation i sheared the poor little bolt. Plan was to drill out and install a shorter, stainless bolt.
Not sure if there was an easier way to get the stud out. This a bad idea or will I be fine? Thanks, Evan. Last edited by evan; 06-04-2011 at 07:52 PM. Reason: spelling |
|
|
 |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5th Gen Suspension -- The Book | JusticePete | Suspension / Brakes / Chassis | 151 | 05-07-2015 06:52 PM |
| Engine heat/Cold Air intake | FosterSS | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 11 | 06-01-2011 09:14 AM |
| OEM air box | Bonemaro | V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment | 3 | 04-26-2011 07:09 PM |
| Noticed something while checking air box | jshaf | 5th Gen Camaro SS LS LT General Discussions | 9 | 11-01-2010 03:45 AM |
| VOLANT POWER CORE COLD AIR INTAKE (CAMARO SS) NOW IN STOCK! | Nick@moranoracing | V8 Bolt-Ons & Tunes | 0 | 06-30-2010 02:45 PM |
