You are browsing camaro5 
 |
|
08-23-2014, 05:47 PM
|
#1 |
|
BLCSWAN
Drives: Camaro ZL1, Toyota 4Runner Join Date: Jun 2012
Location: Maryland
Posts: 100
|
Hood not locking
I installed the ACC full size preforated header plate and after install the hood would not lock. It catches but it will not lock. I took it off just to make sure it was not the plenum cover I also put on but the hood will latch after I remove the header plate. Gonna try the install again. Any ideas?? here is a picture - not that great a pic...
__________________
2012 Black Camaro ZL1, Red Rx Can, Black CAI
|
|
|
|
08-23-2014, 06:32 PM
|
#2 |
      
Drives: SS 1LE Join Date: Nov 2012
Location: Texas
Posts: 1,829
|
Sounds like the latch on the radiator support needs to be moved up slightly
|
|
|
|
|
08-23-2014, 07:15 PM
|
#3 |
|
BLCSWAN
Drives: Camaro ZL1, Toyota 4Runner Join Date: Jun 2012
Location: Maryland
Posts: 100
|
Can I do that without dismantling a lot of stuff?
__________________
2012 Black Camaro ZL1, Red Rx Can, Black CAI
|
|
|
|
|
08-23-2014, 07:49 PM
|
#4 |
|
Drives: SS 1LE Join Date: Nov 2012
Location: Texas
Posts: 1,829
|
Looked at mine and can see the 2 bolts. But the black cover looks like it would have to come off to make it easier to do.
|
|
|
|
|
08-23-2014, 08:33 PM
|
#5 |
|
BLCSWAN
Drives: Camaro ZL1, Toyota 4Runner Join Date: Jun 2012
Location: Maryland
Posts: 100
|
Okay, I see those. Have a few car shows tomorrow and was hoping to get this on but I am running out of steam....will try this later...will post my results
Thanks
__________________
2012 Black Camaro ZL1, Red Rx Can, Black CAI
|
|
|
|
|
08-23-2014, 10:35 PM
|
#6 |
|
BLCSWAN
Drives: Camaro ZL1, Toyota 4Runner Join Date: Jun 2012
Location: Maryland
Posts: 100
|
Removed the original rubber trim piece and reinstalled and hood now latches. Removing the rubber trim is not in the instructions.
__________________
2012 Black Camaro ZL1, Red Rx Can, Black CAI
|
|
|
|
|
|
|
|
 |
| Thread Tools | |
|
|
