You are browsing camaro5 
 |
|
12-22-2011, 05:11 PM
|
#1 |
     
Drives: 2010 ZL550& 2021 C8 Z51 Join Date: Feb 2010
Location: Near Philadelphia
Posts: 1,583
|
Pfadt Trailing arm and 17" Weld wheels???
With all the discussion based on the lower control arms hitting the weld wheels. Does anybody have any knowledge of the Pfadt trailng arms hitting the 17" rims with a lowered car? Getting ready to buy a set of LCA and wondering if I should order BMR trailing arms and sell my Pfadt arms.
__________________
 |
|
|
|
12-22-2011, 05:27 PM
|
#2 |
     |
I know the BMR Trailing arms will hit for sure.. Andy @ ADM grinds and welds the factory LCA's for clearance !!
|
|
|
|
|
12-22-2011, 05:40 PM
|
#3 |
|
Drives: 2010 ZL550& 2021 C8 Z51 Join Date: Feb 2010
Location: Near Philadelphia
Posts: 1,583
|
Just spoke to BMR on the phone they say there arms (both trailing and control arms will clear) Looks like I will have to sell my Pfadt arms early next year.
__________________
|
|
|
|
|
12-22-2011, 05:41 PM
|
#4 |
|
Read up on this thread below. In post #3, "Silverfox" had his 17" Welds rubbing on his Pfadt trailing arms. I haven't heard about any other trailing arms besides these rubbing on the Welds, it's usually the LCA's.
http://www.camaro5.com/forums/showthread.php?t=142523 |
|
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Weld 17" Drag Wheel & Tire Combo! | Jason 98 TA | Wheels / Tires | 8 | 06-22-2011 12:50 PM |
| where to get 17" wheels for my ss with brembos | mozartss | Wheels and Tires Talk Sponsored by The Tire Rack | 1 | 03-30-2011 07:14 PM |
| 17" or 18" Rear Wheels | BlackHot | Dragstrip and Launch Techniques Discussion | 2 | 12-05-2009 12:54 AM |
| 17" or 18" Rear Wheels | BlackHot | Wheels and Tires Talk Sponsored by The Tire Rack | 2 | 12-03-2009 05:52 PM |
