You are browsing camaro5 
 |
|
06-08-2012, 10:51 PM
|
#1 |
 
|
Hatch alingment?
I just noticed that my rear hatch has a small gap towards the left side of the quarter panel all the way to where the back lights are and a huge gap from the right. I can fit my finger and still have room. Is there any way of adjusting this?
|
|
|
|
06-08-2012, 11:30 PM
|
#2 |
|
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
First: Assemble a 2x4(does NOT matter how long) and a BFH/Persuader. NEXT: Lay the 2x4 length wise again the edge of the hatch with the smallest gap. AANNNDD then! Take BFH and start tapping on said 2x4 gentley until adiquate results are required. But before you do any of this you should loosen hinges or whatchamawhogiggies as to not bend the hatch if the Persuader does its job too well.
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler  |
|
|
|
|
06-09-2012, 12:19 AM
|
#3 |
|
|
Okay so Is this "persuader" like a hammer? Lol, and that seems simple enough ima try it out and see what happens.
|
|
|
|
|
06-09-2012, 07:31 AM
|
#4 |
|
Nope! v6.
Drives: 2001 SOM v6 Join Date: Mar 2012
Location: Ottawa, OH
Posts: 459
|
Yeah just be careful so you don't mess anything up
__________________
3" Magnaflow cat-back, MSD 8.5mm Super Conductor Wires, NGK Iridium plugs, KN Air Filter, Halo Headlights, Shaved Air Lid, Chrome ZR1 Rims, SS Hood Scoop/Spoiler |
|
|
|
|
|
|
|
 |
|
|
