People with SS Rivets in Their Painted Engine Covers

[JM20]

Does anyone know the size, etc. of the hardware used below in the fuel rail covered area?

What size hole to drill, any washers used, nut underneath???

Thanks!

[kbeery]

http://www.camaro5.com/forums/showthread.php?t=42523

One of the last paragraphs says what this guy used..also a really cool guide to give the engine cover a pretty unique look

[JM20]

Originally Posted by kbeery

http://www.camaro5.com/forums/showthread.php?t=42523

One of the last paragraphs says what this guy used..also a really cool guide to give the engine cover a pretty unique look

Perfect! Thanks!!!

[2nd SS]

I used Teks Lath Screws (#8 x 1/2" ). They come in a box of 260. I think I got them a Lowes, but it might have been Home Depot. I have CRS, so you might have to try both places. As far as drilling, I think it was a 1/16" bit. Again CRS. Just make sure it is smaller than the screw. These screws are self tapping, so just take your time. Sorry about the pic size, but I just wanted you to be able to see good.

[VR Baron]

I used 1/4-20 and 10-32 button heads scured with a nut on the underside

[JM20]

Dam those look awesome! Just ordered a painted cover from Lupe and going to add these when it comes in. Thanks a million for the replies!

[redirish]

Originally Posted by VR Baron

I used 1/4-20 and 10-32 button heads scured with a nut on the underside

Look good! What did you use to make the Chevrolet white?

[VR Baron]

Originally Posted by redirish

Look good! What did you use to make the Chevrolet white?

They are vinyl decals from reflective, forgot whether that was designs, or ind. Actually are light silver but look white. Under the right light they are a little reflective. You can get all kinds of colors, reflective or regular.Think they were about $20 and the v8 one came free.After I put them on I clear coated to help them from coming off.