Flowmaster Series 10 + Resonator Tips - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

The Black Knight · 06-15-2014, 03:03 PM

well it's taken me long enough to get some video of this. I know in my other thread on the exhaust someone asked for a drive by. Don't have anyone to hold the camera for me, so here's what the exhaust sound like with my GoPro mounted just above the exhaust in the taillight lens.

I had the tips installed at the same time the exhaust was installed. Mainly looking for them to cancel out drone and they do a fine job from inside the car. Not sure how the exhaust would sound with just the Series 10 mufflers.

You can check out some of my other exhaust videos in my channel.

thanks

BigRed585Lbs · 06-15-2014, 04:53 PM

Now, that's a proper sounding exhaust.
Congrats.

The Black Knight · 06-15-2014, 04:59 PM

Quote:

Originally Posted by BigRed585Lbs

Now, that's a proper sounding exhaust.
Congrats.

Thanks I've had the exhaust on the car since last Summer but finally got a GoPro and wanted to get a decent video of how it sounded.

KaBoom1701 · 06-15-2014, 06:23 PM

Congrats.

Sounds great!

dmginc · 06-15-2014, 09:39 PM

sounds a lot like my exhaust but i have a Magnaflow resonated x-pipe and muffler delete. sounds good!

BUTT72 · 06-16-2014, 10:55 PM

I have the 10 series on mine also, but I kept factory tips for now. It was a more budget friendly option, $140 for Mufflers & $90 to have welded on. Love it, especially the price.

The Black Knight · 06-23-2014, 09:06 PM

Quote:

Originally Posted by BUTT72

I have the 10 series on mine also, but I kept factory tips for now. It was a more budget friendly option, $140 for Mufflers & $90 to have welded on. Love it, especially the price.

See that was the situation I was in. l got a smoking deal on the Flowmasters from a local muffler shop. I also got a discount on everything because my company uses them for fleet repair on exhaust systems. I think I got out of there for around $160 with parts and labor after discount.

Quote:

Originally Posted by CreativeDawn

I got Flowmaster Series 10, Spectre CAI, No Resonators, 2.5 inch piping (had 3 but went back to 2.5), 3 inch hpipe and Doug Thorley Shorty Headers

Yeah I bet it sounds great with the headers. Makes it roar a little bit more.

BUTT72 · 06-23-2014, 09:50 PM

Quote:

Originally Posted by The Black Knight

See that was the situation I was in. l got a smoking deal on the Flowmasters from a local muffler shop. I also got a discount on everything because my company uses them for fleet repair on exhaust systems. I think I got out of there for around $160 with parts and labor after discount.

Yeah I bet it sounds great with the headers. Makes it roar a little bit more.

Yeah I couldn't beat the deal. I bought K&N CAI with the money I saved. I plan on changing the tips to matt/flat black soon, but they're more than I want to spend online. So i'll probably just get some PepBoy's/AutoZones for $60 a pair.

RJT Impala · 06-23-2014, 10:33 PM

OP--How about some pictures of the set up? I really like the sound and want to see how it looks. Thanks.

The Black Knight · 06-23-2014, 11:03 PM

Quote:

Originally Posted by BUTT72

Yeah I couldn't beat the deal. I bought K&N CAI with the money I saved. I plan on changing the tips to matt/flat black soon, but they're more than I want to spend online. So i'll probably just get some PepBoy's/AutoZones for $60 a pair.

That's what I did. Snagged my resonator tips from Advanced Auto. I mainly went for them to help cancel drone. Before I did my exhaust I read on here of many people that experienced drone in some form or another. So when I went to have my exhaust done at the shop, I gave them the tips to throw on there just for good measure. Believe it or not, I don't get much drone from the exhaust. Can't really say it's attributed to the tips but I would think they are helping. Only time I get drone and this is weird, is when it rains heavy and either the mufflers get wet or the drastic temperature change(here in Colorado, a storm can drop temps from 90 degrees to in the high 50's as it rolls through) cause them to give off the slightest bit of drone.

Quote:

Originally Posted by RJT Impala

OP--How about some pictures of the set up? I really like the sound and want to see how it looks. Thanks.

Will do, I'll get some tomorrow and upload them here for you. If you watch a couple of other videos, I know one of them shows a rear end shot of me filming the exhaust. But you'll get a chance to hear some of the other clips as well from me revving it in the garage and acceleration on the road from inside the car.

The Black Knight · 06-26-2014, 11:06 PM

Quote:

Originally Posted by RJT Impala

OP--How about some pictures of the set up? I really like the sound and want to see how it looks. Thanks.

Here's some pics I snagged today real quick of what the setup looks like. It's an axle back setup. You can see the Flowmaster Series 10's and had the resonator tips welded on as well. Hope this is what you were looking for.

FlowmasterMufflers · 06-30-2014, 05:30 PM

Sounds great!

The Black Knight · 07-05-2014, 09:54 AM

Quote:

Originally Posted by CreativeDawn

Oh bro..without a DOUBT!!! It sounds meaner and the Doug Thorley Headers are so much lighter then the stock manifold......I think i'm going with Electric Cutouts next and we'll see how that sounds. I keep changing things up on my car...I can never get enough?

I've changed my exhaust system like 6 times, and my cosmetic stripes like 8 times hahahaha.

Lol! 6 time! Wow that's a lot on the quest for the right exhaust tone. Well good luck with if you change it again..

06-15-2014, 06:23 PM	#4
KaBoom1701 KaBoom1701 Drives: 13' ZL1 Red M6 Join Date: Dec 2012 Location: I.E. SoCal (Yucaipa) Posts: 8,631	Congrats. Sounds great! __________________ Mods: Roto-Fab Intake, WW Res. kit & Big Gulp Air Scoop, Elite Catch Can, ATI Super Damper & 18% OD Pulley, LF Idler pulley bracket, Metco CC breather, ID850 Injectors, Stainless Power Headers w/ ceramic coating, TR71X Spark Plugs, JMS Fuel Pump Booster, Bo White TB, Tuned by Ted @ Jannetty Racing, Ron Davis HX, D3 Reservoir, Pfadt 1" Springs, Moreno Camber Plates, ZL1 Addons Splitter guard washers, Tow Hook kit & rock guards, Hurst Shifter Billet Plus 6 Speed Short Shifter, ZL1 DRL lighting harness, ZL1 Recaro Seats.

06-15-2014, 09:39 PM	#5
dmginc Drives: In Circles Join Date: Mar 2011 Location: South Carolina Posts: 3,433 View My Garage	sounds a lot like my exhaust but i have a Magnaflow resonated x-pipe and muffler delete. sounds good! __________________ CAI Cold Air Intake, BMR Strut Tower Brace, BMR 1.2" Lowering Springs Gen5DIY Fog Lights, Big Worm Third Brake Light/Side Marker Tint (Charcoal) GTS Tail Light Covers, Purple Under Hood Lighting Magnaflow Resonated X-Pipe w/ Muffler Delete Black Plasti Dipped Wheels, Z/28 Spoiler

06-15-2014, 04:53 PM	#2
BigRed585Lbs Drives: Sierra and Tahoe Join Date: Jul 2010 Location: By Marion, MS Posts: 1,324 View My Garage	Now, that's a proper sounding exhaust. Congrats.

06-16-2014, 10:55 PM	#6
BUTT72 Drives: 2013 1LT/RS/Auto/ IOM Join Date: Feb 2014 Location: Las Vegas Posts: 63	I have the 10 series on mine also, but I kept factory tips for now. It was a more budget friendly option, $140 for Mufflers & $90 to have welded on. Love it, especially the price.

06-23-2014, 10:33 PM	#9
RJT Impala Stovebolt BluFlame 6 Drives: '12 2LT/RS, IBM; '20 Traverse Prem Join Date: Oct 2011 Location: Wherever! Posts: 893 View My Garage	OP--How about some pictures of the set up? I really like the sound and want to see how it looks. Thanks.

06-30-2014, 05:30 PM	#12
FlowmasterMufflers Drives: 2016 Camaro SS Join Date: Jul 2010 Location: Santa Rosa, CA Posts: 660	Sounds great!