HELP! Service Stabilitrak, A/C Blowing Hot Air, Cruise Control Disengage? - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

camarodade · 07-07-2016, 11:25 AM

Good Morning All,

I have a 2012 Camaro SS with 8,000 miles on it. Manual transmission. This is whats been going on. When driving all of the sudden my A/C will start blowing hot air followed by Service Stabilitrak warning. If im in cruise control it will disengage automatically. It follows a pattern. If I shut the car off for a few then turn it back on, AC is cold and no Stabilitrak lights. It been happening pretty regularly especially if I drive the car for more than a half hour. Brought it to the dealer and they could not replicate the problem because it is intermittent. However there were error codes stored in the computer. They recommended replace steering position sensor and then said I may need an EBCM or a yaw rate sensor. They weren't sure what the problem was. So I replaced the steering position sensor and 3 days later it happened again. Does anyone have any clue what this issue could be. I don't want to just keep blowing money with the "hope" that the issue is fixed. Thanks!

maddoggyusa · 07-07-2016, 02:52 PM

are you the same guy that added the Mylink Nav??

bad ground???

07-07-2016, 11:25 AM	#1
camarodade Drives: 2012 Camaro SS Join Date: Aug 2012 Location: Miami Dade Posts: 5	HELP! Service Stabilitrak, A/C Blowing Hot Air, Cruise Control Disengage? Good Morning All, I have a 2012 Camaro SS with 8,000 miles on it. Manual transmission. This is whats been going on. When driving all of the sudden my A/C will start blowing hot air followed by Service Stabilitrak warning. If im in cruise control it will disengage automatically. It follows a pattern. If I shut the car off for a few then turn it back on, AC is cold and no Stabilitrak lights. It been happening pretty regularly especially if I drive the car for more than a half hour. Brought it to the dealer and they could not replicate the problem because it is intermittent. However there were error codes stored in the computer. They recommended replace steering position sensor and then said I may need an EBCM or a yaw rate sensor. They weren't sure what the problem was. So I replaced the steering position sensor and 3 days later it happened again. Does anyone have any clue what this issue could be. I don't want to just keep blowing money with the "hope" that the issue is fixed. Thanks!

07-07-2016, 02:52 PM	#2
maddoggyusa Drives: 2013 Camaro Dusk 2SS/6 Join Date: Sep 2013 Location: New Jersey Posts: 1,586	are you the same guy that added the Mylink Nav?? bad ground???