![]() |
|
|
#1 | |
![]() ![]() ![]() ![]() ![]() ![]() Drives: 2015 1LS Red V6 Join Date: Aug 2015
Location: St Joseph, MO
Posts: 1,849
|
My thoughts on Solo HFC's vs Catless downpipes
I went with the Solo HFC's earlier this year because I did not want to lose any torque on the bottom going with catless.
The Solo's were nice. The sound was great with the Magnaflow X pipe and muffler delete-i believe Sanjay and myself have posted the videos a few times. I decided to give the other end of the spectrum a try-DGM sold me a set of Catless downpipes that have no rear O2 bungs, and added a bung for a wideband. Got them installed, and with my Overkill Tune, and everyting else ive done, have not noticed any loss in torque. I feel like above 4k RPM (which is where i live most of the time, due to the 3.91's) I have picked up quite a bit of power. I am pretty pleased with them throughout the power band. As for the tone/sound, i have picked up a little bit of rasp, from 2500-3000RPM, and a bit of drone from 2700ish to 3000, which sucks because my 70mph cruise speed in 6th is right at 2700. There is a slight vibration/buzz as well at low RPM. Sanjay, Ghosted and myself are still trying to locate where/what that is. The smell....I LOVE the smell. Especially when running E85. MMMM yeah! The big reason why i switched was to ditch the rear O2's and tune them out, and to simplify my wideband setup. I was pleasently surprised to see and feel more power in the mid to top end, without the loss in the bottom that I was expecting. That could be due to the other modifications I have as well. Questions, comments, concerns, outbursts?
__________________
Sponsors:
Overkill Motorsport BCS Auto JacFab Machining APDEG Dream Gear Mobile Audio Thanks to Will @ Overkill Motorsports, Jason @ JacFab, Jim @ Ohio Speed, Brandon at Dream Gear, and the boys at Randy Curnow Chevrolet 5th Gen V6 Performance Facebook Group |
|
|
|
|
|
|
#2 |
![]() ![]() ![]() ![]() ![]() ![]() Drives: 2015 1LS Red V6 Join Date: Aug 2015
Location: St Joseph, MO
Posts: 1,849
|
And...sorry its been so long since ive posted...been busy with some other mods, and running at the local strip.
__________________
Sponsors:
Overkill Motorsport BCS Auto JacFab Machining APDEG Dream Gear Mobile Audio Thanks to Will @ Overkill Motorsports, Jason @ JacFab, Jim @ Ohio Speed, Brandon at Dream Gear, and the boys at Randy Curnow Chevrolet 5th Gen V6 Performance Facebook Group |
|
|
|
|
|
#3 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2017 ZL1 A10 & 2021 BMW M340i x Dr Join Date: Mar 2009
Location: Tampa
Posts: 5,111
|
Do you have a before and after the non converter time slip?
__________________
Sold 2012 2LT RS 12.3@112 old setup
Sold 1967 Camaro Pro Street. Ran 10's mild BB on NOS. 2017 HyperBlue ZL1 A10 ** Born 3/17/17**Delivered 4/08/17 2020 Build: Mag2650, BTR Stage2, NW103, BG, 14% lower, 90mm upper, ARH 2" Long system w/no cats, SW Legend mufflers. **807hp/762tq on 93 gas** and **848hp/792tq on e47** Sold 2018 (Go Mango) Dodge Charger Daytona 392 Daily Driver Daily Driver 2021 BMW M340i Xdrive |
|
|
|
|
|
#4 |
![]() ![]() ![]() ![]() ![]() ![]() Drives: 2015 1LS Red V6 Join Date: Aug 2015
Location: St Joseph, MO
Posts: 1,849
|
I dont.
I didnt hit the strip for the first time until last Friday :-(
__________________
Sponsors:
Overkill Motorsport BCS Auto JacFab Machining APDEG Dream Gear Mobile Audio Thanks to Will @ Overkill Motorsports, Jason @ JacFab, Jim @ Ohio Speed, Brandon at Dream Gear, and the boys at Randy Curnow Chevrolet 5th Gen V6 Performance Facebook Group |
|
|
|
|
|
#5 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() |
Derek did you do a before and after Dyno run to see the change ?
__________________
|
|
|
|
|
|
#6 | |
![]() ![]() ![]() ![]() ![]() ![]() Drives: 2015 1LS Red V6 Join Date: Aug 2015
Location: St Joseph, MO
Posts: 1,849
|
Quote:
Planning a few hour dyno session here hopefully soon. Gotta come up with the funds though.
__________________
Sponsors:
Overkill Motorsport BCS Auto JacFab Machining APDEG Dream Gear Mobile Audio Thanks to Will @ Overkill Motorsports, Jason @ JacFab, Jim @ Ohio Speed, Brandon at Dream Gear, and the boys at Randy Curnow Chevrolet 5th Gen V6 Performance Facebook Group |
|
|
|
|
|
|
#7 |
|
Account Suspended
Drives: 2013 1LT RS Camaro Join Date: Apr 2016
Location: Southeast Michigan
Posts: 3,494
|
What et's are you dropping Derek?
|
|
|
|
|
|
#8 |
![]() Drives: 2015 1ls Join Date: Nov 2015
Location: kentucky
Posts: 86
|
i have an ear like a hawk when it comes to my car and have been looking for this buzz that a few people have mentioned with no luck, hope it doesnt settle into one lol
__________________
mods: roto-fab CAI. VMAX ported throttle body
|
|
|
|
|
|
#9 |
![]() ![]() ![]() ![]() ![]() ![]() Drives: 2015 1LS Red V6 Join Date: Aug 2015
Location: St Joseph, MO
Posts: 1,849
|
Not great. Have never run on the drag strip before, so this is all new to me.
Having terrible traction issues, didnt adjust tire pressures, or make any changes, as I was just trying to learn launching, staging, and etiquette.... Next time ill drop pressures and start launching higher in the RPM's, as I was getting a lot of wheel hop.
__________________
Sponsors:
Overkill Motorsport BCS Auto JacFab Machining APDEG Dream Gear Mobile Audio Thanks to Will @ Overkill Motorsports, Jason @ JacFab, Jim @ Ohio Speed, Brandon at Dream Gear, and the boys at Randy Curnow Chevrolet 5th Gen V6 Performance Facebook Group |
|
|
|
|
|
#10 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2017 ZL1 A10 & 2021 BMW M340i x Dr Join Date: Mar 2009
Location: Tampa
Posts: 5,111
|
drag radials will help alot!!
__________________
Sold 2012 2LT RS 12.3@112 old setup
Sold 1967 Camaro Pro Street. Ran 10's mild BB on NOS. 2017 HyperBlue ZL1 A10 ** Born 3/17/17**Delivered 4/08/17 2020 Build: Mag2650, BTR Stage2, NW103, BG, 14% lower, 90mm upper, ARH 2" Long system w/no cats, SW Legend mufflers. **807hp/762tq on 93 gas** and **848hp/792tq on e47** Sold 2018 (Go Mango) Dodge Charger Daytona 392 Daily Driver Daily Driver 2021 BMW M340i Xdrive |
|
|
|
|
|
#11 |
![]() ![]() ![]() ![]() ![]() ![]() Drives: 2015 1LS Red V6 Join Date: Aug 2015
Location: St Joseph, MO
Posts: 1,849
|
Yeah, i have a lead on some...i just dont want to get too heavily invested as i have my car setup for road course.
BUt i am already pricing radials, a line lock, and other goodies....it was a freaking blast.
__________________
Sponsors:
Overkill Motorsport BCS Auto JacFab Machining APDEG Dream Gear Mobile Audio Thanks to Will @ Overkill Motorsports, Jason @ JacFab, Jim @ Ohio Speed, Brandon at Dream Gear, and the boys at Randy Curnow Chevrolet 5th Gen V6 Performance Facebook Group |
|
|
|
|
|
#12 | |
![]() Drives: 2015 AGM 1LT Join Date: Jul 2015
Location: Lakeland, Florida
Posts: 198
|
Quote:
|
|
|
|
|
|
|
#13 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2015 Black 2LT RS M6 Join Date: Aug 2015
Location: Cali
Posts: 2,033
|
I got a concern......put that 4x4 closer to the pavement. She'll launch harder, get better 1/4 mile times and it will instantly add like 10,000 followers to your Instagram account.
Well it will at least look better
__________________
Overkill tune/E85/80mm•CAI cold air intake w/my custom maf tube•Apex air scoop•JacFab ported intake/Extendolater•Vitesse•EE EX2 catch can•Innovate wideband•ARH HFC's•NPP exhaust•11386 xpipe•Brembos/cross drilled/slotted rotors•SS M/C•Pfadt 1.25 springs•1LE struts/sways/strut tower brace•BMR diff bush, trail arms/bush, adj toe links•My custom Tunnel brace•Hurst short throw shifter•JDP stage 1 clutch res•1LE steering wheel, shift boot•ZL1 rear diffuser/splash guards•GM splitter•Z/28 grille/flowtie/spoiler/wheels•GM performance pedals•"Chevrolet" door sills•10" Kicker sub•BigWorm overlays
|
|
|
|
|
|
#14 |
![]() ![]() ![]() ![]() ![]() ![]() Drives: 2015 1LS Red V6 Join Date: Aug 2015
Location: St Joseph, MO
Posts: 1,849
|
Lol....yeah yeah...well, when i get paid back....ill get some ordered ;-)
__________________
Sponsors:
Overkill Motorsport BCS Auto JacFab Machining APDEG Dream Gear Mobile Audio Thanks to Will @ Overkill Motorsports, Jason @ JacFab, Jim @ Ohio Speed, Brandon at Dream Gear, and the boys at Randy Curnow Chevrolet 5th Gen V6 Performance Facebook Group |
|
|
|
|
|
|
|
![]() |
|
|