You are browsing camaro5 
 |
|
11-28-2018, 11:03 AM
|
#1 |
 
Drives: 2014 ZL1 M6 , 95 Ram 2500 Cummins Join Date: Oct 2016
Location: Greenville, NC
Posts: 11
|
23% Lower Pulley - Cooling Lines interference
Has anyone installed the 9.55 Lower pulley on a M6 LSA?
If so, what did you do about the trans/dif. cooling lines? I just finished my install, and had to use zipties to keep the lines down since they were touching the lower pulley. I was curious what everyone else has done in this situation. I think the lines are 5/8 OD so I was going to buy a AN10 hose separator clamp and try to make a bracket for it. |
|
|
|
11-28-2018, 01:12 PM
|
#2 |
|
Team 913
Drives: '14 ZL1, '15 Jeep GC, ‘22 Ram 2500 Join Date: Apr 2015
Location: USA, Central CA
Posts: 1,119
|
Zip tied to frame
|
|
|
|
|
11-28-2018, 10:29 PM
|
#3 |
|
fo'shizZL1
Drives: 2017 ZL1 Join Date: Aug 2017
Location: ATL
Posts: 1,791
|
yep. ditto with the 10"
__________________
2017 ZL1 M6 Black | Maggie 2650 // 103TB // Big Gulp // CSP LT's & Ultra Cats // BMR MM // BC Forged KL13
Mods being installed- oil pump, cam, ported heads, dual in-tank, Goliath and XDI, corn, etc., etc. |
|
|
|
|
|
|
 |
|
|
