18's from a 2010 on a 3rd Gen F-Body

[SS_in_Black]

I did some searched on this but couldn't find any info. Anyone know if the stock 18's from a 2010 will fit on a 3rd Gen camaro? 3rd Gen center bore is 2.788" (70.8mm) and a 4.75" pattern.
Thanks

[Andro]

Originally Posted by SS_in_Black

I did some searched on this but couldn't find any info. Anyone know if the stock 18's from a 2010 will fit on a 3rd Gen camaro? 3rd Gen center bore is 2.788" (70.8mm) and a 4.75" pattern.
Thanks

I'm pretty sure the bolt pattern on the 2010 camaro is slightly different like milimeters then the 3rd gen camaro's

[SS_in_Black]

Originally Posted by SS_in_Black

I did some searched on this but couldn't find any info. Anyone know if the stock 18's from a 2010 will fit on a 3rd Gen camaro? 3rd Gen center bore is 2.788" (70.8mm) and a 4.75" pattern.
Thanks

After some further research I guess I've answered my own question... no.

2010 Camaro Except SS

Bolt Pattern: 5x120 (4.72")
Center Bore: 67mm
Hardware: 14x1.50 Lug
Offset:
Front: 34mm
Rear: 38mm

It could be done if you ground down the center bore 3.8mm but that's a bit much and I would question the wheels integrity at that point. You would also need to offset quite a bit in order to get inner wheel well clearance. You could also not use the stock tire size. It's too tall. You would need to have a 40 or less in order to use 18" wheels for fender clearance. Not sure if this helps anyone but me but it's informational for everyone nonetheless.