![]() |
|
|
#1 |
![]() Drives: 2010 2SS/RS 6MT Join Date: Dec 2009
Location: Savannah, GA
Posts: 258
|
Question about noise for those with M6
This happens warm or cold and I wanted to know if it was normal or a possible problem...
I noticed that while I am coasting at slow speeds (usually in a parking lot, 1st or 2nd gear) and go to put the clutch in I will hear a fairly loud clunk noise when I press it in and its all the way engaged. It wont happen everytime but I'd say about 1/3rd or 1/2 the time. Is this normal with these cars as I never heard anything like that with my last car? |
|
|
|
|
|
#2 |
![]() ![]() ![]() ![]() |
I think the problem is that the clutch is completely disengaging all at once instead of slowly. I do not think it has anything to do with the cold, just clutching technique. It took me a while to get used to the load on the clutch with the horsepower of the LS3.
|
|
|
|
|
|
#3 |
![]() Drives: 2010 2SS/RS 6MT Join Date: Dec 2009
Location: Savannah, GA
Posts: 258
|
No, I mean I can be coasting about 15 mph in neutral then go to put the clutch in and put the car in 2nd and when I press down on the clutch and the car is rolling it will make a clunk noise...does that make sense?
|
|
|
|
|
|
#4 |
|
Account Suspended
Drives: SuperCharged 2SS/RS IOM MN6 Join Date: May 2009
Location: CA
Posts: 5,094
|
normal
|
|
|
|
|
|
#5 |
![]() ![]() ![]() ![]() |
I've never noticed anything like that. Like I tell everyone, I'd take it to the dealer and take the mechanic out and show him. If it ends up being something of importance, GM will bulletin it so everyone can have their car checked out.
|
|
|
|
|
|
#6 |
|
The Mark of Excellence
Drives: 2010 ABM 1SS RS LS3 Join Date: Jan 2009
Location: Smallest State in the Union
Posts: 8,688
|
Raise the engine speed a little, that may stop the clunk. I know it is a fully synchronized transmission, but you are probably hearing some driveline slack.
__________________
BMR, CAI, DynoMax, Elite Eng., Hurst, Jannetty, Clear Image Headers & Hi Flow cats, Jet Hot, LSR, TSW, VMax, Vredestein |
|
|
|
|
|
#7 |
|
Maros_eat_Stangs
Drives: 2010 Blk/Blk 2SS/RS M6 Polished 20s Join Date: Oct 2009
Location: Hattiesburg, MS
Posts: 23
|
I had the same thing happen to me the other day twice. Once at the drive thru and again at a stop sign. It was loudest at the stop sign. I was headed down a slight decline to the stop sign at slow speed (still in 1st actually). When I pressed in the clutch I heard a fairly loud bang. It has only happened at slow speeds when I press the clutch in fast. I started easing the clutch in and haven't noticed it since. I haven't driven a manual in 10 years so I just thought I was a little rusty.
__________________
'95 Camaro V6 Purple/Grey
'96 Camaro RS V6 Blk/Blk '97 Camaro Z28 V8 Red/Red&Blk '99 Trans Am V8 Red/Blk |
|
|
|
|
|
#8 |
![]() Drives: 2010 2SS CGM LS3 Join Date: Jan 2010
Location: SF Bay Area
Posts: 236
|
Mine does it too. If you disengage the the clutch a little earlier it helps.
|
|
|
|
|
|
#9 |
|
Virologist in the making
Drives: 2010 VR SS/RS LS3 Join Date: Aug 2009
Location: El Paso TX
Posts: 2,865
|
I have some noise too coasting around 7-15mph in a parking garage. To me it sounds more like a hollow, metalic snort or gurgle than a clunk. Like if a robot had a sinus infection and blew its nose... if you can imagine... lol It also sounds like it is coming from underneath the right in the middle (right under the back seat.)
__________________
Victory Red 1SS/RS Ordered - 8/4/09 & Joined Camaro5.com family
6000, Delivered to the customer - 12/21/09 ![]() |
|
|
|
|
|
#10 |
![]() Drives: 2010 CGM 2SS/RS 6M Join Date: Feb 2010
Location: Bonaire, GA
Posts: 258
|
I've been searching around in here and I've been experiencing the same clunking/rattle type noise when I disengage the clutch at low speeds (10mph), like you would do in bumper to bumper traffic. Has anyone gone to the dealership for this yet? If so, did you get an explanation?
Thanks, Rich |
|
|
|
|
|
#11 |
|
Junkie
|
mine does it too.. while pulling in the garage.. ive heard it.
not all the time tho.. 1st time it scared the crap out of me.. it echoed and sounded a lot louder i thought my tranny was blowing up. :-)
__________________
|
|
|
|
|
|
#12 | |
![]() Drives: 2010 CGM 2SS/RS 6M Join Date: Feb 2010
Location: Bonaire, GA
Posts: 258
|
Quote:
|
|
|
|
|
|
|
#13 |
![]() Drives: 2010 2SS/RS 6MT Join Date: Dec 2009
Location: Savannah, GA
Posts: 258
|
Yeah my 2006 Civic SI's clutch/transmission did not make a single noise and it was $22,900 brand new haha. If there is a fix for this eventually I want in! For now it's not a huge deal I guess.
__________________
'10 2SS/RS 6MT, Silver Ice Metallic/Black, CAI Inc Intake, Magnaflow 3'' Catback Exhaust 16483, Llumar 35% Tint, Headlight Armor 20% for Fog/Side/Tail Light Lenses
![]() |
|
|
|
|
|
#14 |
![]() ![]() Drives: 2010 RY 2SS/RS Join Date: Dec 2007
Location: Miami
Posts: 828
|
I had a similar issue with the GTO, mainly this comes from a 2 piece drive shaft. Does this car have a 2 piece or solid drive shaft? I have heard it slightly on the Camaro also, the fiix is basically to press the clutch a hair slower.
|
|
|
|
|
|
|
|
![]() |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intermittent clicking noise at low speeds | I8A4RE | Camaro Issues / Problems | Warranty Discussions | TSB and Recalls | 11 | 01-07-2015 05:30 PM |
| Strange noise that follows engine rpm - 2SS/RS | SSCam15 | Camaro Issues / Problems | Warranty Discussions | TSB and Recalls | 76 | 11-17-2011 12:00 AM |
| 2SS M6 Transmisson noise | gtjacket | 5th Gen Camaro SS LS LT General Discussions | 15 | 12-16-2009 09:24 PM |
| ticking noise and high pitched hum | strshp5 | 5th Gen Camaro SS LS LT General Discussions | 13 | 10-21-2009 05:04 PM |
| Front end noise | Chevy Jim | Wheels and Tires Talk Sponsored by The Tire Rack | 2 | 07-01-2009 03:12 PM |