You are browsing camaro5 
 |
|
09-02-2014, 09:44 PM
|
#1 |
   Drives: 2017 ZL1 Join Date: Aug 2009
Location: Maryland
Posts: 1,052
|
Stock ZL1 exhaust fitment.
I was wondering just where the tips of your exhaust sits on your ZL1. Mine sits flush with the bumper, but I've seen several others that sit as much as 1.5" past the bumper. I'm wondering where the difference is coming from. How does this escape GM quality control? Is there that much "play" in the exhaust where it can be adjusted a couple inches either way?
__________________
'17 ZL1 10.99@129 stock. 4225# raceweight. Best 60'- 1.66 on factory tires. 10.48@132 E50, intake and tune. 4270 lbs
https://youtu.be/EyHtdH9XOkY https://youtu.be/Lcu41obbTf8 '13 ZL1 BRM A6. 11.591 @ 119.2 factory stock with a 1.68 60'! Best stock mph 121.8. 11.29 @ 123 RotoFab, drag radials and skinnies. 4360# raceweight. http://youtu.be/yggIA3C_kkA 2014... back to stock http://youtu.be/spQLaTWbThs 2013... stock & RotoFab |
|
|
|
09-02-2014, 10:56 PM
|
#2 |
 
Drives: ZL1 Join Date: May 2012
Location: Kansas
Posts: 109
|
I noticed my driver's side muffler/tip assembly is backed almost all the way out of the rubber hanger. I haven't been motivated enough to get under the car and work on it. My tips are flush with the bumper... maybe even a little bit recessed.
__________________
2014 BRM ZL1 #229
Rotofab, VMax, Moroso, MGW I used to be schizophrenic, but we're okay now. |
|
|
|
|
09-03-2014, 07:30 AM
|
#3 |
        
Drives: 2017 Mosaic Bk ZL1 M6 Join Date: Jul 2009
Location: South of Raleigh, NC
Posts: 9,615
|
Mine are even in that regard but the driver side tips are about a half inch higher than the pass side.
__________________
 |
|
|
|
|
09-03-2014, 09:37 AM
|
#4 |
|
Drives: 2013 ZL1 Ashen Gray Join Date: Oct 2013
Location: Lawrenceville,Ga
Posts: 668
|
Mine were even when I got my car but since I've put on LTH,off road pipes,"X" pipe.
There is play in the exhaust to move it back and forth,I put mine to stick 1in. passed the rear valence. |
|
|
|
|
|
|
|
 |
| Thread Tools | |
|
|
