05-25-2017, 09:22 PM | #1 |
V6 stillen splitter install?
can someone please show pics of how to install a stillen splitter on a 13,
|
|
05-26-2017, 10:34 AM | #2 |
BITCHN Camaro
Drives: SOLD! Back in the looking zone... Join Date: Feb 2015
Location: Saline, MI
Posts: 248
|
Have you inquired with Stillen?
__________________
BITCHN
|
05-26-2017, 01:55 PM | #3 |
no their directions say to use 3m double sided tape to hold the whole thing in and i was just going to use 3 self tappers and 3m double sided tape to hold the sides on
|
|
06-07-2017, 01:46 AM | #4 |
This Is Bumblebee
|
Stillen Install
I installed mine a few months ago. I would not recommend relying solely on the tape, as it is prone to wear off. With that said, I used the tape to place it on the bumper until I could drill the holes for screws and fender washers. On the three supports at the nose of the splitter, I used one stainless bolt and fender washer on each of those. Just the bolt on the outside drilling into the splitter and through the underside of the bumper; topped off with locknuts and fender washers. I also put two recessed bolts in each side with fender washers on each. that thing is not coming off. Once the bolts were on, I used black paint to blend in the screws with the rest of the splitter so they are hidden. This isn't the best picture of the splitter but you can get the idea that there are no bolts showing. I'll see if I have any other pics to upload. Good Luck.
__________________
|
|
|
Thread Tools | |
|
|