You are browsing camaro5 
 |
|
10-05-2014, 01:20 PM
|
#1 |
|
BUMBL Z
|
access to reverse light wiring
is there any way to access the harness(es) that go to the reverse lights without dropping the bumper? i really only need leads to wire in additional reverse lights, don't really need access to the housing itself
__________________
Sold: 2015 ZL1 M6, Rotofab Intake, LS3 throttle body, 2.55 Upper/9.17 Lower, Custom Camshaft, DMS Reinforced Brick, ID1050X, 1 7/8" Headers, ProSpeed HX/Reservoir, DSX Aux Pump/Flex Fuel Sensor, E85, McLeod RXT, BMR 1" Drop, 680rw 93/750rw E85, Tuned by CSP
Sold: 2010 2SS, some bolt ons, 415rwhp/400rwtq  Last edited by spadz93; 10-05-2014 at 02:49 PM. |
|
|
|
10-05-2014, 03:53 PM
|
#2 |
Drives: 2014 Z/28 #82+#192, 18ZLE 66Nova Join Date: Oct 2008
Location: By the lake in AZ
Posts: 15,728
|
Yes all you do is open the trunk, when you do look at the drivers side where the plastic cover is over the tail lights, remove it, the harness is there, you need the light green wire in the end its the 12V+ for the reverse light's, but ground is on the other side of the tail lights.
|
|
|
|
|
10-05-2014, 08:34 PM
|
#3 |
 
Drives: Black 2011 2SS/RS / Black 2013 ZL1 Join Date: Feb 2012
Location: El Paso, Texas
Posts: 314
|
 
|
|
|
|
|
10-05-2014, 08:36 PM
|
#4 |
|
BUMBL Z
|
Perfect. Thanks guys!
__________________
Sold: 2015 ZL1 M6, Rotofab Intake, LS3 throttle body, 2.55 Upper/9.17 Lower, Custom Camshaft, DMS Reinforced Brick, ID1050X, 1 7/8" Headers, ProSpeed HX/Reservoir, DSX Aux Pump/Flex Fuel Sensor, E85, McLeod RXT, BMR 1" Drop, 680rw 93/750rw E85, Tuned by CSP
Sold: 2010 2SS, some bolt ons, 415rwhp/400rwtq |
|
|
|
|
|
|
|
 |
|
|
