Dash Part # Identification

[elarson5757]

Wondering if anyone can tell me if the section of the dash where my Scorpion Emblem is attached is replaceable on my 2013 1LE? And if so can someone help with the part number?

I'm searching but having a hard time finding the right schematic...

Eric

[2SSRS@Gen5diy]

Thats the dash, and you can replace it but your looking at 5 hr min, to get the parts need to know, if you have HUD and or center speaker.

[elarson5757]

Originally Posted by 2SSRS@Gen5diy

Thats the dash, and you can replace it but your looking at 5 hr min, to get the parts need to know, if you have HUD and or center speaker.

It's a 1LE so it's not the SS dash. It appears to me that is an insert that is vinyl in the 1LE and alantra or suede in the ZL1...

[elarson5757]

Originally Posted by 2SSRS@Gen5diy

Thats the dash, and you can replace it but your looking at 5 hr min, to get the parts need to know, if you have HUD and or center speaker.

And frankly I'd prefer the ZL1 inserts that are suede with the red stitching. It LOOKS like these part numbers maybe?

SUEDE INSERT PASS SIDE#22880755
DRIVERS SIDE INSERT#22757136

I'm guessing there is screws under the top plastic trim and push connectors of some sort along the bottom and top of the radio...not sure however..

[justjoshin]

Check with A_DILLA, he swapped this out in his car.

http://www.camaro5.com/forums/showpo...1&postcount=70

http://www.camaro5.com/forums/showpo...2&postcount=71

[2SSRS@Gen5diy]

Originally Posted by elarson5757

And frankly I'd prefer the ZL1 inserts that are suede with the red stitching. It LOOKS like these part numbers maybe?

SUEDE INSERT PASS SIDE#22880755
DRIVERS SIDE INSERT#22757136

I'm guessing there is screws under the top plastic trim and push connectors of some sort along the bottom and top of the radio...not sure however..

1le or SS or ZL1 or Z/28 or LT its all the same dash from 2012 up, what you want is different trims.

[elarson5757]

Yep. Confirmed those are the right part numbers for the ZL1 dash inserts and the swap is simple. Pulled my current ones out in about 10 minutes.

[elarson5757]

Originally Posted by 2SSRS@Gen5diy

1le or SS or ZL1 or Z/28 or LT its all the same dash from 2012 up, what you want is different trims.

Sorry you just had me confused when you said that section I was referring to where my emblem is mounted was the dash itself and was a five hour job. Thankfully the section itself is a simple few minute swap. Thanks for your input.