Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Roto-Fab
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > General Camaro Forums > 5th Gen Camaro SS LS LT General Discussions


Reply
 
Thread Tools
Old 06-23-2015, 05:38 PM   #1
Grims8ball
 
Drives: 2011 Camaro 2SS/RS Supercharged!
Join Date: Oct 2011
Location: Arlington, TX
Posts: 7
Rocker panel help!

For a little back story first...
I bought my 2011 Synergy green Camaro with 8,200 miles. There were custom carbon fiber side skirts that were taped along the rocker panels and then screwed into the fender wells. The car was lowered by an inch when I bought it and the custom skirts fell another inch and a half. I caught one of those pesky curbs and destroyed the passenger side skirt. When I did it caused some damage to the screw mounting in the rear fender well...JUST ON THE ROCKER PANEL! I took the 1 and a half skirts off that I still had on. When I did a lot of that tape was left on my rocker panels and it looks very tacky.

I've been looking for a set to replace them with, but haven't been able to find any on the Internet or even some side skirts from a body kit that replace the panels instead of just going over. I was wondering if anyone knew where I could find some replacement rocker panels or side skirts that replace the existing ones. Or does anyone at least know of a safe way to remove what is left of the tape from the side skirts I pulled off?

The only place I've found replacement panels is at the dealership at a very high cost.
Grims8ball is offline   Reply With Quote
Old 06-23-2015, 05:44 PM   #2
Homeless Man
Homeless Life Chose Me
 
Homeless Man's Avatar
 
Drives: LS3 (sold 4/21)
Join Date: Nov 2014
Location: Streets of Philly
Posts: 3,648
Well some pictures might help
__________________
Pity a man in familiar places, who yet feels like a stranger.
Homeless Man is offline   Reply With Quote
Old 06-23-2015, 05:52 PM   #3
ZYBORG
Lets roll...
 
ZYBORG's Avatar
 
Drives: 14'
Join Date: Jun 2014
Location: TX/S.FL
Posts: 1,495
Quote:
Originally Posted by Grims8ball View Post
For a little back story first...
I bought my 2011 Synergy green Camaro with 8,200 miles. There were custom carbon fiber side skirts that were taped along the rocker panels and then screwed into the fender wells. The car was lowered by an inch when I bought it and the custom skirts fell another inch and a half. I caught one of those pesky curbs and destroyed the passenger side skirt. When I did it caused some damage to the screw mounting in the rear fender well...JUST ON THE ROCKER PANEL! I took the 1 and a half skirts off that I still had on. When I did a lot of that tape was left on my rocker panels and it looks very tacky.

I've been looking for a set to replace them with, but haven't been able to find any on the Internet or even some side skirts from a body kit that replace the panels instead of just going over. I was wondering if anyone knew where I could find some replacement rocker panels or side skirts that replace the existing ones. Or does anyone at least know of a safe way to remove what is left of the tape from the side skirts I pulled off?

The only place I've found replacement panels is at the dealership at a very high cost.
Pics would help, but sounds like you are looking for replacement side skirts.

I have a black set thay I am looking to sell. Let me know if you are interested.
__________________
ZYBORG is offline   Reply With Quote
Old 06-23-2015, 06:04 PM   #4
Grims8ball
 
Drives: 2011 Camaro 2SS/RS Supercharged!
Join Date: Oct 2011
Location: Arlington, TX
Posts: 7
Grims8ball is offline   Reply With Quote
Old 06-23-2015, 06:10 PM   #5
christianchevell
old school chevy rodder
 
christianchevell's Avatar
 
Drives: 2021 zl1 a-10 WildCherry
Join Date: Jul 2012
Location: Oregon
Posts: 5,622
http://www.camaro5.com/forums/showth...ht=zl1+rockers
__________________
2021 Wild Cherry ZL1 A10, Sunroof, Data,Red Carbon Interior, Nav, RotoFab Big Gulp , Elite x2ultra, Borla ATAK, Driveshaft shop, BMR susp, Speed covers, intercoolers, ATI , 2650 MAG, DSX lid, 103 NW, TSP Longtubes & cats, LPE, 1le mods, ,LME cover, Katech pump and chain, Trunnions, BTR stage 2, LPE boostapump, Gforce, Speed eng , Granetteli, etc etc
christianchevell is offline   Reply With Quote
Old 06-23-2015, 06:20 PM   #6
Grims8ball
 
Drives: 2011 Camaro 2SS/RS Supercharged!
Join Date: Oct 2011
Location: Arlington, TX
Posts: 7
Quote:
Originally Posted by christianchevell View Post
thank you very much for the link. Ill look into a set of those...does anyone know a good way i can get that tape gunk off until i get new panels?
Grims8ball is offline   Reply With Quote
Old 06-23-2015, 06:56 PM   #7
rccamaro
 
rccamaro's Avatar
 
Drives: 2014 Camaro 2SS/1LE
Join Date: Apr 2012
Location: San Jose, CA
Posts: 94
In a week I'll be receiving ZL1 side rockers for my 2014 ILE.
I can sell you my original side panels for $250 including shipping. They are black.
Let me know by PM so I'm alerted of the message.
rccamaro is offline   Reply With Quote
Old 06-23-2015, 07:04 PM   #8
Demon War Horse
War Horse Pilot
 
Demon War Horse's Avatar
 
Drives: 2017 NFG 1SS 1LE
Join Date: Jul 2014
Location: N.Texas
Posts: 2,458
Quote:
Originally Posted by Grims8ball View Post
thank you very much for the link. Ill look into a set of those...does anyone know a good way i can get that tape gunk off until i get new panels?
3M adhesive remover spray. Auto parts store. Well ventilated area. Might also use a heat gun or hair drier to get the majority off. Don't use too much heat and go slow. Rub with microfiber towels that you will toss. It will ruin them, but it works.
__________________
COTW 09/07/2015 - 2014 AGM 2SS/RS - RIP 6/01/17
2017 Nightfall Gray Metallic 1SS 1LE Born 5/17/17 - Click Sig Pic below for for Demon War Horse 02 Build Thread

SigPic by Hazman
Demon War Horse is offline   Reply With Quote
Old 06-23-2015, 07:45 PM   #9
Grims8ball
 
Drives: 2011 Camaro 2SS/RS Supercharged!
Join Date: Oct 2011
Location: Arlington, TX
Posts: 7
Quote:
Originally Posted by rccamaro View Post
In a week I'll be receiving ZL1 side rockers for my 2014 ILE.
I can sell you my original side panels for $250 including shipping. They are black.
Let me know by PM so I'm alerted of the message.
i appreciate the offers to buy the ones your removing but i really want them color matched and to get them painted after buying them would cost me around the same to just go ahead and purchase a set of those ZL1 panels that was displayed in the link.
Grims8ball is offline   Reply With Quote
 
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:36 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.