You are browsing camaro5 
 |
|
06-05-2018, 01:03 PM
|
#1 |
 
Drives: 2010 ecs SS Join Date: Oct 2014
Location: Ca
Posts: 34
|
Ecs bad pulley bearings.
Hey fellas,I got the ecs novi 1500 I noticed after a 3rd gear pull a noise that seemed like a gridding or chatter from the engine bay, poped the belt off to find a bolt backed out on an idler pulley and a good amount of play in the tensioner pulley. looking to see if someone can chime in a bit of theyre knowledge on this. wondering if ill need new pulleys or I could just swap the bearings out. Thanks in advance
__________________
2010 M6, Ecs Novi 1500, BTR Cam, Zl1 driveline, Rxt Clutch, M/T Et street S/S
Last edited by Johnnyrod; 06-05-2018 at 06:43 PM. |
|
|
|
06-05-2018, 02:30 PM
|
#2 |
  Drives: Black 2SS RS w/White Stripes Join Date: Mar 2011
Location: Katy, TX
Posts: 775
|
I would give ECS a call. They are pretty helpful from previous experience.
__________________
2010 2SS/RS "ChriSStine":
Pat G Custom Turbo CamMotion Camshaft | AGP TT BB Garrett 62/65's | AGP/Fore Triple Pumps | ID1700X Injectors | Alky Control Twin Nozzle Meth | Custom 3" Exhaust | 3.27 gear set w/ Tru Trac | McLeod Twin RXT | Barton Short Throw Shifter | 6th Gen ZL1 Wheels | BMR 1.4" drop springs | Pfadt rear trailing arms & tie rods | Installed by Me & Tuned by Pat G |
|
|
|
|
06-05-2018, 02:34 PM
|
#3 |
|
Drives: 2010 ecs SS Join Date: Oct 2014
Location: Ca
Posts: 34
|
Thanks for the reply, I did get in touch but looking for more opinions see If theres an easy way out lol
Sent from my SM-G900W8 using Tapatalk
__________________
2010 M6, Ecs Novi 1500, BTR Cam, Zl1 driveline, Rxt Clutch, M/T Et street S/S
|
|
|
|
|
|
|
|
 |
|
|
