You are browsing camaro5 
 |
|
11-25-2020, 11:55 AM
|
#1 |
 
Drives: 2013 Camaro SS 6-Speed Join Date: Nov 2017
Location: Lansdale,PA
Posts: 411
|
Z28 CAI Issues
Just installed a z28 cold air intake yesterday. Probably my favorite intake so far for the 5th gen. Only issue I'm having is its pushing on the hood. I understand its supposed to seal against the hood but it looks like its pushing it up a little. Anyone else have this issue??
__________________
 2013 Camaro 1SS 6-Speed LS3 All stock.. For now... |
|
|
|
11-25-2020, 02:05 PM
|
#2 |
|
Fast Cars and Old Guitars
Drives: 2015 2SS RS (L99, baby!) Join Date: Apr 2012
Location: N. CA
Posts: 4,210
|
Yes!! Did you notice that on the bottom of the bucket I’ll call it, there’s a ball and socket affair. There’s a small plastic ball on the end of a little plastic stud that sits down into a part of the body as I recall. It’s easy to think that you have it in place and the inch or so is all the difference between sitting up too high and wrinkling the hood liner and being in the right position to seal properly. You’ll feel it snap in place when it’s in the correct position.
__________________
“I don’t want to belong to any club that would have me as a member.” - Groucho Marx
|
|
|
|
|
11-25-2020, 02:08 PM
|
#3 |
|
Fast Cars and Old Guitars
Drives: 2015 2SS RS (L99, baby!) Join Date: Apr 2012
Location: N. CA
Posts: 4,210
|
The rubber grommet might be stuck on the old OE intake. I can’t remember if the OE intake had a similar ball and socket holder but I think it did.
__________________
“I don’t want to belong to any club that would have me as a member.” - Groucho Marx
|
|
|
|
|
|
|
|
 |
|
|
