Molded Splash Guards

[rydahog]

i just installed these on my 2010 2lt...took about 45 mins,,,easy as cake..

i had to jack the front up 2 inches,,i did not have an angle drill or i would not have had to jack it at all...the back is even easier,,got them for about $144 plus shipping,,less then an week delivered.. Gm perfparts in N, carolina?
hang on let me look..
here it is
http://www.gmpartsdirect.com/
good luck..
mine were cyber gray to suit my ride..

[Synergy SATX]

Green with black

[renke]

Different Views

[christyhulin]

Originally Posted by Grandeos

Designers are responsible for the way the car looks... and could care less what engine gets thrown in it. And as far as looks are concerned.... SPLASH GUARDS are a NO NO. For that, why dont you get a black car-bra, curb scratchers, and hell... why not get a body-side molding for door dings while you are at it..... GRANDPA.
I dare you to find one picture of the concept car with splash guards. Or a sketch of the Camaro with splash guards.....

Go ahead........ Im waiting

I love my car, and the way it looks without the splash guards. What I don't love is what the dirt and grime are doing to the paint. I have tiny chips all over the area behind the front and rear tires and I do not drive it on dirt roads. I think they are a necessity, wether they were meant to be on there or not. And I think they do look good. To each his own, right!

[Elykson]

On my list for the near future! Gonna go with the black ones to match the rest of the black on my Victory Red.

[camguy]

check out these lemans style air diffuser / air extractor guards... shown here on an R8 Matches intakes of front and exhaust side of the Audies air extractors and engine compartment ... imagine they'd look equally stellar on camaro. The lines look like the intake gills of the Camaro...

[skar]

I think they must be painted to match car. And then I am still not sure.
? Any photo of IMPERIAL BLUE METALLIC

[BLU DUCE]

Originally Posted by Jimmy

Has any one see a picture of the Camaro with molded splash guards? I noticed is is an option... I am not sure the cost. All of the cars I have purchased over the years off of the lot have had splash guards. They have always looked good so I assume they would look good on the Camaro as well. Has anyone requested this on their orders? I don't remember being asked if I wanted them.

Go to members build journal and look at my build. Under Spike III IBM SS/RS L99, I have them on mine.

[Bradrulz]

Anyone know the push pin retainer size and the screw size that comes with these? I bought a set from a guy selling hem on camaro5, but didn't have the install hardware. Mi know you end up using some existing screws from the car, but looks like you should have some push pins and some screws.

[batman53201]

I just bought some black ones on ebay. My winning bid..................$5.00

[The MOAC]

Hey synergy satx, sorry to be a stickler but you should fix your CAMARO lettering. I saw how crooked it was instantly.