![]() |
|
|
#1 |
![]() Drives: 2011 Chevy Camaro LT1 Join Date: Apr 2016
Location: Philadelphia
Posts: 14
|
I have a 2011 LT about 59k on the dash, the other day I started experiencing problems. The check engine light is on my car shakes at idle, and slow acceleration when in drive. I had the CHeck engine light code read and got 17 of them all random misfires ex. P0300,P0306 and etc and a Mass Air Flow sensor code.. I just replaced the sensor and it's still doing the same thing., any thoughts on might be wrong and where to go next??
|
|
|
|
|
|
#2 |
![]() Drives: 2014 1SS Join Date: Feb 2014
Location: Cornelius,NC
Posts: 124
|
If you have a Cold Air Intake, check the hoses to see if they are loose. You will hear a slight hiss if this is the problem
|
|
|
|
|
|
#3 | |
![]() Drives: 2011 Chevy Camaro LT1 Join Date: Apr 2016
Location: Philadelphia
Posts: 14
|
Quote:
I have a spectre cold air intake, before having this problem I always heard a whistling noise when accelerating. I will check the hoses tho, I have a ? After changing the sensor was there anything else I needed to do? I know the computer prob was reading the old sensor I'm wondering if putting a new one in that it would pick up on the new sensor |
|
|
|
|
|
|
#4 |
|
Camaros of NorthWest Ohio
Drives: 2012 LS Join Date: Oct 2015
Location: luckey,oh
Posts: 58
|
Disconect your battery for about 15 minutes or so to clear the codes in the computer and then u should be fine.
Sent from my SM-G900P using Tapatalk
__________________
2012 ls 20in rims,cai,oil catch can,throttle body spacer,billet grill,axle back exhaust,vitesse throttle control,red oracle headlight halos, red oracle afterburner taillights,blacked out windows,oem strutt tower brace polished and painted
|
|
|
|
|
|
#5 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2011 1LT/RS A6 RJT SuperCharged Join Date: Mar 2011
Location: 87114
Posts: 3,501
|
Your throttle body sensor could be going bad.
__________________
Power is worthless without control. The 2nd protects the 1st.
BMR sub frame brace, BMR tunnel brace, LSR sways, LSR CM ca & tl, Sphon ExD el, GM tower brace, Megan EZ Streets, Goodridge Stainless Steel Braided brake lines, PowerStop D/S rotors & pads, Doug Thorty Ceramic Shorties, Magnaflow x-pipe, MRT V2.0, KICKER PowerStage sub & amp, Infinity speakers & tweeters, Viteese Throttle Controller, Viteese Paddle Shifters, ACS T2 Splitter, ACS T2 Ports/Quad LED lights, VDI kit, Havoc diffuser, IPF ECU/TRANS tuned, IPF/KPE Supercharged. 364RWHP/297RWTQ |
|
|
|
|
|
#6 |
![]() Drives: 2011 Chevy Camaro LT1 Join Date: Apr 2016
Location: Philadelphia
Posts: 14
|
|
|
|
|
|
|
#7 |
![]() Drives: 2011 Chevy Camaro LT1 Join Date: Apr 2016
Location: Philadelphia
Posts: 14
|
|
|
|
|
|
|
#8 |
|
Camaros of NorthWest Ohio
Drives: 2012 LS Join Date: Oct 2015
Location: luckey,oh
Posts: 58
|
Its in the trunk under the floor mat in the middle..you will need a 10mm to remove the neg ( black cable )
Sent from my SM-G900P using Tapatalk
__________________
2012 ls 20in rims,cai,oil catch can,throttle body spacer,billet grill,axle back exhaust,vitesse throttle control,red oracle headlight halos, red oracle afterburner taillights,blacked out windows,oem strutt tower brace polished and painted
|
|
|
|
|
|
#9 |
![]() Drives: 2011 Chevy Camaro LT1 Join Date: Apr 2016
Location: Philadelphia
Posts: 14
|
|
|
|
|
|
|
#10 |
|
Camaros of NorthWest Ohio
Drives: 2012 LS Join Date: Oct 2015
Location: luckey,oh
Posts: 58
|
Yup..
Sent from my SM-G900P using Tapatalk
__________________
2012 ls 20in rims,cai,oil catch can,throttle body spacer,billet grill,axle back exhaust,vitesse throttle control,red oracle headlight halos, red oracle afterburner taillights,blacked out windows,oem strutt tower brace polished and painted
|
|
|
|
|
|
#11 |
![]() Drives: 2011 Chevy Camaro LT1 Join Date: Apr 2016
Location: Philadelphia
Posts: 14
|
|
|
|
|
|
|
#12 |
|
Camaros of NorthWest Ohio
Drives: 2012 LS Join Date: Oct 2015
Location: luckey,oh
Posts: 58
|
No it just lyes there
Sent from my SM-G900P using Tapatalk
__________________
2012 ls 20in rims,cai,oil catch can,throttle body spacer,billet grill,axle back exhaust,vitesse throttle control,red oracle headlight halos, red oracle afterburner taillights,blacked out windows,oem strutt tower brace polished and painted
|
|
|
|
|
|
#13 |
|
Camaros of NorthWest Ohio
Drives: 2012 LS Join Date: Oct 2015
Location: luckey,oh
Posts: 58
|
U have to get the edge of it and pull up..then in the center there a ring u unscrew and the the hard peice comes up then theres ur battery
Sent from my SM-G900P using Tapatalk
__________________
2012 ls 20in rims,cai,oil catch can,throttle body spacer,billet grill,axle back exhaust,vitesse throttle control,red oracle headlight halos, red oracle afterburner taillights,blacked out windows,oem strutt tower brace polished and painted
|
|
|
|
|
|
#14 |
![]() Drives: 2011 Chevy Camaro LT1 Join Date: Apr 2016
Location: Philadelphia
Posts: 14
|
I got it now, didn't know it had a center ring.. So wait about 15mins n then plug that black cable back up? N hopefully this should fix it, if that's the case
|
|
|
|
|
|
|
|
![]() |
| Tags |
| camaro lt/rs, maf sensor, misfire, engine, v6, 2lt |
| Thread Tools | |
|
|