03-28-2016, 03:58 PM | #29 |
|
Cool, can't wait to see them.I am working on my fogs right now. Even worse you have to cut them open with a saw or dremel. I have seen them done on a bandsaw and figured I would give it a new twist so I cut mine open today on a wet tile saw. They came out excellent.The wet saw leaves a nice clean edge, I didn't even need to sand or file them after. All I needed to do was to clean a few burs of plastic off with an razor knife.
|
03-28-2016, 05:55 PM | #30 |
Drives: 2015 Summit White Camaro LS Coupe Join Date: Jan 2016
Location: Los Angeles, CA
Posts: 60
|
here are a couple pics!
|
03-28-2016, 06:41 PM | #31 |
LocoBee in da RGV
Drives: '10 Custom RY 1LT, '14 BlK SS/RS Join Date: Jul 2010
Location: Raymondville. Texas
Posts: 590
|
Have you tried the NightOwl version...says you don't have to bake the lights... https://nightowlleds.com/kits/halo-kit-v2
__________________
It is better to deserve honors and not have them than to have them and not deserve them.
2010 Camaro 1Lt Custom 2014 Camaro 2SS/RS Custom |
03-28-2016, 08:23 PM | #32 |
|
Well if you don't open the headlight housings I suppose you are just putting them on the outside which doesn't appeal to me but i would be interested to see a set installed.I checked the link and the description is pretty vague lol.
|
03-28-2016, 08:25 PM | #33 |
|
|
03-29-2016, 04:07 PM | #34 |
Drives: 2014 Camaro Ls Manual Join Date: May 2015
Location: Miami, Tampa, Florida
Posts: 61
|
Those lights use a already RS car and connect to the halos and change the color. Germy was putting halos into a non RS camaro which does require baking the headlights no matter what company.
__________________
2014 Ls, Magnaflow resonated x-pipe, Oracle halos, K&N CAI, Elite Engineering Catch Can
1995 Z28 Auto, LT Pacesetter Headers, y-piped to 80 series Flowmaster, K&N Cai. |
03-29-2016, 05:07 PM | #35 | |
Drives: 2015 Summit White Camaro LS Coupe Join Date: Jan 2016
Location: Los Angeles, CA
Posts: 60
|
Quote:
Hence our lights are illegal, how did you wire them and do you have a switch? can i PM you my number to text? |
|
03-29-2016, 05:16 PM | #36 | |
Drives: 2014 Camaro Ls Manual Join Date: May 2015
Location: Miami, Tampa, Florida
Posts: 61
|
Quote:
If you'd like to send me your number i've got no problem helping out in any way.
__________________
2014 Ls, Magnaflow resonated x-pipe, Oracle halos, K&N CAI, Elite Engineering Catch Can
1995 Z28 Auto, LT Pacesetter Headers, y-piped to 80 series Flowmaster, K&N Cai. |
|
03-29-2016, 10:01 PM | #37 |
|
Install your own switch to power them independently so you have full control all the time.Here is where I put mine.
|
03-31-2016, 04:53 PM | #38 |
|
Ok here is pic of what I mean.Hope this makes sense to you.Orange line is what you tap into in console.Run wire fom there to switch then from other side of switch to LEDS. You can ground the LEDS anywhere you want. You also need a ground wire for the switch light. But when you pop off the side panel on the console you will see there is a ground post close to your foot to connect to.Cant remember exactly which color wire in console I tapped into so not necessarily orange.
|
03-31-2016, 05:23 PM | #39 | |
Drives: 2015 Summit White Camaro LS Coupe Join Date: Jan 2016
Location: Los Angeles, CA
Posts: 60
|
Quote:
|
|
03-31-2016, 05:31 PM | #40 |
|
OK just looked up wiring diagram although it is from 2010 LS and it shows that the 2 outlets in the console are powered by 2 different wires, one outlet is green wire and the second outlet is green wire with white stripe. So if wiring is the same on your 2015 then either of those wires would be fine to tap into for a positive power source.
|
04-02-2016, 05:37 PM | #41 |
|
2 different ways to wire the switch
Top view shows the switch light always on Bottom view shows the switch light only on when switch is activated The last unused terminal is used if you want to reverse the switch so that it would be activated with the switch up and then shut off when you press switch down, but I am sure you don't want that. Personally I chose(top option) always on so I could see the switch lit up at night whether it is on or off |
04-04-2016, 09:30 AM | #42 |
Drives: 2015 Summit White Camaro LS Coupe Join Date: Jan 2016
Location: Los Angeles, CA
Posts: 60
|
Dave,
Wanted to chime in for an update. It took us about an hour or so to set it up! I dont know why my friend had a hard time figuring out the diagram, but everything works wonderfully. I will post pictures when i can! I love the button! Great recommendation. |
|
|
Tags |
halo, lights, oracle |
Thread Tools | |
|
|