You are browsing camaro5 
 |
|
05-18-2024, 01:57 PM
|
#1 |
         
Drives: 2010 RS Inferno Orange Metallic Join Date: Mar 2010
Location: Albany, Ga.
Posts: 3,408
|
oil pressure sending unit
Quite strange with the Oil pressure sending unit very easy to replace, but my gauge was showing ether 0 oil pressure or 70+ oil pressure after engine was warmed up (199-203) Engine no damage, but i never got a check engine Light
or Check Gauges anybody else get this strange oil pressure reading?
__________________
Hot Wheels Emblems and Floor Mats, Morimoto Fog Lights, PCP Hideaway Headlight Covers, BBK Headers & High Flow Cats, ZL1 Add-ons Wicker Bill, TL1/ZL1 Hood Insert, Gen5 DIY Frameless Mirror, ABL Dash Lighting & My link Navigation, Blacked out Rear Bowtie, all Sylvania led Turn Signals, Ceramic Window Tint By Nicks, MBRP Exhaust tips, GEN5 DIY Virginia Legal DRL Harness, Painted Brake Calipers, Vittesse Throttle Controller & Paddle Shifter Heritage Grill, Manual Shifter Boot, CNC Throttle Body, Trifecta Tune, Trunk Black out and Side Grills, Hot Wheels door Sills.
 |
|
|
|
05-21-2024, 06:05 PM
|
#2 |
 
Drives: 2011 2SS, 2006 GMC Sierra Join Date: Jul 2019
Location: MA
Posts: 266
|
Scan for codes you will probably find oil pressure sensor circuit codes like a P0522 or P0523, You can disconnect the oil pressure sensor and test the circuits
With the ignition in RUN, test the Gray wire for 5 volts. Test the Black wire for ground. Test the Tan/White wire for less than 4.8 volts. If the circuits test good replace the oil pressure sensor |
|
|
|
|
05-28-2024, 05:27 AM
|
#3 |
|
i would say change sensor
__________________
David Vianu
2010 Synergy Green 1LT |
|
|
|
|
|
|
|
 |
|
|
