2014-2015 Non-RS Camaro Headlights @ Phastek Performance

[Sales@Phastek]

Originally Posted by aris20

what about fog lights that match this headlight/taillight combo ?

Sorry about the delay with getting back to ya.

The factory fog light bulbs are H11, so I would say the CREE bulbs that we have will be a close match.

Originally Posted by Ivolcom

I have these headlights and I have been looking for some good and bright led bulbs for them. The bulbs I have tried have not projected the light well enough to drive safely at night. Can anyone link me the kind I need to get?

The bulbs size is an H7 for both the high and low beam.

Thank you,
Ricardo

[oglk]

http://www.camaro5.com/forums/showth...403679&page=10

The ones linked in that thread is what i used and they're PLENTY bright

[Rgm400]

Have you had any issue with them? I'm thinking about purchasing some but would like too see more pictures of car from ppl in this forum? Mind showing yours? Thanks

[oglk]

Na not a single problem

[Rgm400]

That's clean bro! & thanks for the quick reply cuz!

[acp1996]

Hey, I'm interested if you have any deals for headlight/taillight combo too?

[fuson]

If I put a HID pojecter headlight kit in my 2014 ls2 I would have to buy a set of 4 but how would the high and low beam work since there separate?

[Sales@Phastek]

Originally Posted by fuson

If I put a HID pojecter headlight kit in my 2014 ls2 I would have to buy a set of 4 but how would the high and low beam work since there separate?

When putting in HID kits you will wire them to the same power and ground as the factory halogen bulbs. Unless you have a relay harness, which is normally suggested. At this point you the lights will get the power from the relay harness and feed it to the lights. 1 relay harness per set of light is what is needed, so harness will control 2 lights.

So the HID lights will work the same. They should come on with the low beam and the high beam when they are turned on just like normal.

Thank you,
Ricardo

[fuson]

Ty for the help Ricardo. So the HID high/low beam should work for both right?

[fuson]

This is not exact one but close http://66.135.209.70/itm/PAIR-2-8-CA...333?nav=SEARCH

[Sales@Phastek]

Originally Posted by fuson

Ty for the help Ricardo. So the HID high/low beam should work for both right?

Yes, an HID system will work for both high and low beam. The high will not kick on as fast as they are ment too, only because HID bulbs take some time to warm up before they are at full brightness. In these headlights I do beleive the high and low beam are the same size.

Originally Posted by fuson

This is not exact one but close http://66.135.209.70/itm/PAIR-2-8-CA...333?nav=SEARCH

This might not work. Since this kit is a projector replacement it might not work in these headlights. If they are able to bolt in place then yes they will work but we have not replaced the projectors in these headlights yet to know if they will work.

No problem answering the questions, I just hope what I am typing is understood.

Thank you,
Ricardo

[fuson]

Yes sir it is I think you very much

[Tdenton55]

Looking for package front an rear with LED bulbs

[Sales@Phastek]

Originally Posted by Tdenton55

Looking for package front an rear with LED bulbs

PM sent