JANNETTY RACING DIPSTICK & TUBE KITS 6L80E & 6L90E

[JANNETTYRACING]

Originally Posted by leemozoid

A little feedback. These need to be about 2-3" longer for the Gen 5. As is they are too damn close to the headers to comfortably check when hot and running. It's great, but you will lose some knuckle skin if you're not careful.

Thank you for the feedback, you might consider having your headers coated this will eliminate the issue and increase performance.

Ted.

[tartagliazl1]

I got mine yesterday thanks Ted.

[JANNETTYRACING]

Originally Posted by tartagliazl1

I got mine yesterday thanks Ted.

You are very welcome hope you enjoy it.

Ted.

[JANNETTYRACING]

Originally Posted by Smitty CC

My question is what is the procedure for checking the trans … IE ...fluid temps,run thru gears ect… after install.
Also having headers I appreciate your suggestion but have you considered what the post implies and lengthen the tube and stick? See I can be snarky too.

The procedure is the same as GM suggests, except you no longer need a lift or another person to help.

This is from the service manual

The transmission fluid level must be checked when the transmission fluid temperature (TFT) is between 30-50°C (86-122°F). If the TFT is not within this range, operate the vehicle or allow the fluid to cool as required. Setting the fluid level with a TFT outside this range will result in either an under or over-filled transmission. TFT>50°C=under-filled, TFT<30°C=over-filled. An under-filled transmission will cause premature component wear or damage. An over-filled transmission will cause fluid to discharge out the vent tube, fluid foaming, or pump cavitation.

Observe the Transmission Fluid Temp using the driver information center (DIC) or a scan tool.
Start and idle the engine.
Depress the brake pedal and move the shift lever through each gear range. Pause for at least 3 seconds in each range. Move the shift lever back to PARK. Ensure the engine RPM is low (500-800 RPM).
Allow the engine to idle for at least 1 minute.

Set the fluid level to the top of the Hash marks.

No we will not be lengthening the tube.

[JANNETTYRACING]

Originally Posted by Smitty CC

Yes Thank you, I suspected it would be the same temps ect … but just checking. Now all I need to do is calculate if I can get it past the mods. of which I have no Ideal. Oh also is there a bracket that holds it in place?

Looks like a great product for people who really take care of their own cars. Hey GM some of us can be trusted to follow the directions and do it ourselves just like before. Oh well let me do some checking...talk to you soon.

Yes you can see it in the picture on my site https://jannettyracing.com/products/...it-6l80e-6l90e

Ours sets the level correctly as not to uncover the filter.

GM level saves a quart on every trans they build LOL.

Ted

[JANNETTYRACING]

Originally Posted by Smitty CC

Yes I now see it on the bell housing there... looks solid... So it pushes down into the hole in the trans like a cork and is held there by the bracket. Just like the old days?
BTW I have heard GM was a bit sloppy about fluid levels... even over fill... Hey thanks again ...

Yes sir has a nice Silicone seal we provide.

[JANNETTYRACING]

Been a long time since we bumped these up boy they are super popular selling 10 or more a week, if you don't have one you need one.

Ted.