07-06-2018, 03:36 PM | #1 |
FOUR T 5
Drives: 2012 Camaro 45th Join Date: Feb 2012
Location: Chicago Suburbs
Posts: 749
|
ZL1 Add-ons Jack Points Don't Fit?
I have a 2012 SS with ZL1 Rockers--
I bought ZL1 Add Ons jack points from a member, and just tried to put them on. In the rear, they fit over the pinch weld, but in the front, they do not. For those familiar with ZL1 rockers, there is only a small cutout in the front and rear of the rockers for the jack points to fit, so I cannot slide the jack point forward or back without cutting the rocker. Thoughts?
__________________
|
07-09-2018, 07:38 AM | #2 |
FOUR T 5
Drives: 2012 Camaro 45th Join Date: Feb 2012
Location: Chicago Suburbs
Posts: 749
|
BUMP
__________________
|
07-09-2018, 07:59 PM | #3 | |
|
Quote:
Maybe I'm over simplifying this in my mind. the Jack pad isn't meant to be a permanent part of the car . Instead of sliding it down the pinch rail remove it from the pinch rail and move the jack and the pad to the other end and put the pad in place and jack it up.
__________________
Mods, K&N CAI ,VTC , GM Perf Axleback Exhaust, Elite Eng CC and CSS, GM Strut Tower Brace,Carbon Fiber Anvil Spoiler,ASC T5 Splitter,Gen5diy Foglight kit.
|
|
07-09-2018, 08:18 PM | #4 |
Drives: '14 1LE Join Date: Nov 2013
Location: NJ
Posts: 2,435
|
They are made to fit in the small cutouts in the front and rear of each rocker. You need 4 pads, one for each cutout. Why would you need to slide them forward or back?
|
07-10-2018, 09:36 PM | #5 |
FOUR T 5
Drives: 2012 Camaro 45th Join Date: Feb 2012
Location: Chicago Suburbs
Posts: 749
|
I have 4 pads, I don't need to slide them (I was just saying I can't try a different location because that's where the rockers have the cutouts).
The problem is that where the cutout is, in the front, the jack pad will not fit over the pinch weld. edit - ZL1 addons asked me to send pics, I just had the time during daylight yet.
__________________
|
|
|
|
|