Edelbrock E-Force Dyno

[AlSuwaidi]

WOW im in love!

[DarricSS]

Love the look of that SC...looks factory...

And OMG Torq!

[B.Buster]

Looks like E-Force will give Maggie a run for the money

[racerx333]

nice job mike! need to get him a cam!!!

[PJ droopy pants]

Originally Posted by ADM PERFORMANCE

This was the first one that tried our system.

I see a couple small changes and we will have a kit..ASAP

I would be interested in one for sure when the kit is complete, where is the MAF sensor I dont see it in the pic?

[Sack Rat 2SS]

Very observant. The MAF is inside the sealed airbox, out of engine compartment heat etc. Not for sure but the ADM Perf is the only CAI I am aware of that does this. Looks like it came with the E-Force supercharger kit. It is a very high quality unit.

[lock]

Originally Posted by Mike@RMCR

The valley cover was miss-machined on the oil level sender. They did not tap it enough for a proper seal on the crush collar. We actually had to bore out the hole more and retap the threads. It visually looked fine was only off just a little but was enough to to cause a drastic leak.

For anyone else installing this kit I would check that the sender seats fully on the crush collar. Other than that it was a great and simple kit to install.

As far as the IAT I will check my logs tomorrow. The only other bummer was they sent coil covers for a C6 Corvette. We are still waiting on the right ones.

These #'s are SAE corrected so these #'s should be the same anywhere in the country.

Thanks for all the reply's.

Are you referring the the oil sensor on the rear of the block? I finished my install and it runs awesome. I have noticed an oil leak though. Looks like Im popping it back off tonight but Im curious if I may have the same issue you saw but I dont quite understand what you are saying.