LiquiVinyl V.3 Front Splitter

[davesnever]

Originally Posted by Spec

I'm liking this trim even more this morning. I'm going to leave it. Its a smaller profile than the 1" extruding rubber one I had on previously. A more subtle look, and I think it goes with the light mods on my ride.

A keeper. Pics below.

Fins are next... likely doing this tomorrow if its not too hot. Its been 100, and hearing even hotter today. Pics to finally follow on that. Been brain screwing this splitter too much.....

The theme is looking awesome and I have to agree with your more subtle choice of trim. Now it makes me wonder if some black trim under your ground effects would compliment it?

[Spec]

Originally Posted by davesnever

The theme is looking awesome and I have to agree with your more subtle choice of trim. Now it makes me wonder if some black trim under your ground effects would compliment it?

IKON has some great looking side rockers...


https://www.drivenbystyle.com/2010-2...CABEgJyOfD_BwE


Hmm... I wonder if I can modify those to fit my 3dCarbon set...

[davesnever]

Originally Posted by Spec

IKON has some great looking side rockers...


https://www.drivenbystyle.com/2010-2...CABEgJyOfD_BwE


Hmm... I wonder if I can modify those to fit my 3dCarbon set...

Yeah I was thinking about something like that or even if you wanted something simpler you could just but aluminum strips and paint them black and use your same rivet technique. Either way you would achieve the same goal. I always like to play in photoshop first to get a sneak peek lol.

[Camaro2ss2010]

Originally Posted by Spec

IKON has some great looking side rockers...


https://www.drivenbystyle.com/2010-2...CABEgJyOfD_BwE


Hmm... I wonder if I can modify those to fit my 3dCarbon set...

Different strokes for different folks. Those look like step bars for a truck to me. But my opinion does not matter as it’s not my car. I would be afraid I would step out and rip it off.