03-24-2013, 03:39 PM | #1 |
Drives: 2011 SS/RS Join Date: Apr 2011
Location: Kentucky
Posts: 47
|
ADM FPCM
Can anyone post up a link for the fpcm for the ZL1 pump? I can't find it on their site.
Thanks |
03-24-2013, 04:41 PM | #2 |
Drives: 2012 Camaro SS Join Date: Oct 2011
Location: NC
Posts: 657
|
Pm or call Andy. Great product. It does the trick and the data log will prove it
|
03-24-2013, 05:09 PM | #3 |
Drives: 2012 Camaro SS. L99 Join Date: Nov 2012
Location: Panama City FL
Posts: 113
|
|
03-24-2013, 05:14 PM | #4 |
PHAT B33
Drives: 2012 TF3 Camaro 2SS/RS M6 Join Date: Jun 2012
Location: Dark of the Moon
Posts: 1,460
|
Ya, he added it a few weeks ago.
__________________
Another 1 of 371 '12 T3 LS3 M6's built.
|
03-24-2013, 05:58 PM | #5 |
Drives: 2011 SS/RS Join Date: Apr 2011
Location: Kentucky
Posts: 47
|
Thanks a lot.
How hard was it to get to the fpcm? I know you have to remove the back seat and the side panel, but other than that is it pretty a straight forward install? |
03-24-2013, 06:09 PM | #6 |
Drives: 2011 2SS Convertible Supercharged Join Date: Nov 2010
Location: WI Cert Welder Navy NSSN
Posts: 1,157
|
Easy as pie.
|
03-24-2013, 06:49 PM | #7 |
Drives: 2012 Camaro SS Join Date: Oct 2011
Location: NC
Posts: 657
|
Yep removing the seat was the hardest part
|
03-24-2013, 09:58 PM | #8 |
Syntax Error
|
I did it without removing the seat, just pulled the rear pass side panel back far enough to swap it out, wasn't too tough.
|
03-25-2013, 06:46 AM | #9 |
Removing the rear seat is fairly easy as well, if you choose to go that route. It is not necessary to remove any bolts. Pull up on the front of the lower seat to unclip and unhook at the back by pushing down where the hooks are (located maybe a foot from either side). To remove the top part of the seat, pull it down as if you are trying to accesss the trunk and use the latches at either side to release the seat back from the tubular mount and pull up. There are DIYs on here with pics if needed.
|
|
|
|
|
|