DIY - Solo High Flow Catalytic Converters Installation

[SynergyGreenSS]

Originally Posted by PandaSS

Just have a few questions before I dive into installing mine.
1. Did you reuse the stock band clamps? If not, where did you find new ones?
2. I saw tightening to 18 lb ft recommended in this thread, but the service manual for replacing stock cats recommends 35 lb ft. I will use 35 lb ft for the bolts on the band clamps, but what do you recommend for the exhaust manifold to HFC connection?

Thanks in advanced

I reused the stock clamps. You could get new ones at most auto part stores I believe. I didn't have a torque wrench so I just went with tight enough. Nothing's loosened up yet so I think as long as you get it pretty tight you'll be fine

[rich2342]

Subbed.