03-31-2010, 06:07 PM | #1 |
Drives: 2012 GMC Sierra Z71 4x4 Crew Join Date: Feb 2010
Location: San Antonio, Tx
Posts: 1,229
|
Temporary cover for fuse box
So I had some concerns about dirt or water getting into my fuse box while the cover was at the paint shop. Did not want to ride around all week with it exposed. Here is an inexpensive solution. Went to wal-mart and bought a rubbermaid black plastic drawer tray $4.47 and a roll of black duct tape $3.37. Shortened the tray by cutting it and sliding it into itself to get the proper fit. width was good. Taped all the rough edges and taped it to the base. Due to the added height I had to temporarily remove the ram piston that lifts the hood until the original cover is done.
|
04-01-2010, 12:43 AM | #2 |
|
Nice I just used some ziplock bags and ziptied them to cables/wires I could reach. But this is probably better haha.
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
For Sale GM Vehicle Cover/Engine cover | edog | Exterior Parts & Accessories | 12 | 04-03-2010 08:11 PM |
Fuse Box Cover | CamaroDreams07 | Camaro V6 LLT Engine, Exhaust, and Bolt-Ons | 6 | 03-03-2010 12:46 AM |
Huge Car Cover Sale | southerncarparts | Exterior Parts & Accessories | 11 | 01-12-2010 07:29 AM |
Official GM Car Cover (Grey) | 69Firebird | Cosmetics and Lighting Modification Discussions | 17 | 04-13-2009 09:33 AM |